Type: Posts; User: Cky
That's a lot wildman.i was able to contact the owner of UE so I could get my refund for the busted dogbone.I decided to take matters into my own hands and search for something that would be the right...
after Installing the chassis extension I noticed that the center dogbone is way too short,Go figure UE does not give you spec on the length of the dogbone so I just assumed it would work.After some...
Integy use to make them for revos.
Summit chased by quadcopter
Any updates? Funds run out ?
I never would think the heavy truck can float on snow when it's up to speed...it was a very fun day but it's time for summer.
Indeed, its just unfortunate when nothing holds up at all.at this point Im considering 4wd 1/5 scale vehicle in near future.
Should have kept the rear diff locked.
Get aluminum diff cups,shim the diff and use boca bearings.
It's somewhat fine with loose slipper clutch,punch control at 100% and 35% max braking power.
Any updates ?
Here is another short clip,this time it's on level ground.
It's snowing here folks! Perfect time to take out the summit.here a small clip,it's too bad it blew the rear diff on me :$#!!: fortunatley I have another one that's built and ready to go.
That's awesome! Btw impeccable craftsmanship :thumbup:
What will this vehicle be used for? This truck is above and beyond anything I have ever seen.
Amazing work !
Yes it will.
Awesome! If you could mesure the OD it would be great.i am having problems with Mip's drive shaft pins snapping on me and I wonder if there's anything out there that's stronger.
Sounds like a perfect combination.dont forget to shim everything.
Few questions.what powerplant do you have? how thick are HR pins ?
Bad new folks! Diff blew again....and here is the culprit.Gpm hardened diff cup gear is junk! There are few major problems with how it was made,from what I can see the teeth are a bit thinner and the...
Great job!! Wow i bet you out a lot of work into all that fpv.what cameras are you using for inside vehicles ?
It would be worth a shot.i wonder if they have anything that won't need lube.
Yes,but that's only with stock bearings.i can recall few times when stock bearings would fail and let the pinnion gear woble around,destroying everything inside but this time it's the plastic cup...
Alright I have another one for everyone to see and share some opinions with what happened here.
I am not sure how this bearing sleve got deformed but is seems like the inside bearing got pushed...