Search:

Type: Posts; User: fsantiago1979

Search: Search took 0.01 seconds.

  1. nevermind, it was so blindingly obvious, i missed...

    nevermind, it was so blindingly obvious, i missed it. i just slid the whole piece back onto the starter shaft, twisted CW to lock it on, then pulled the gear wheel off the bearing. then i took the...
  2. Installing roto-start on TRX 3.3 engine

    Hello again,

    So I'm removing my ez-start in exchange for a roto start in my slayer-pro. One issue I'm having is how in the edit do I remove the OWB from the ez-start gear assembly it's mounted in...
  3. Replies
    1
    Views
    241

    GoPro usage with Slayer pro

    Anyone out there know of an existing off the shelf mount for a gopro on a slayer pro? I'd rather not use the sticky pads on my body plus I don't believe that would hold up well. Just looking around...
  4. Replies
    1
    Views
    536

    White grease coming out of ez start

    Today I tried starting the engine and the ez start motor wouldn't turn. I realized my engine had become flooded so I corrected that and ran it just fine. Afterwards during my after run cleanup and...
  5. upgrading slayer pro radio system to TQi

    when i received my new slayer, it had the TQ system included. i presume to upgrade to tqi, this involves a new TX and RX, plus probably some telemetry sensors. Does anyone have specifics, how to...
  6. is that as simple as opening it and using...

    is that as simple as opening it and using pre-existing screw holes or is that a custom mod involving drilling and what not?
  7. silly question - transmission shifting (or lack there of)

    Is there any way to set the two-speed tranny to not shift at all, making it act like a single speed? This is on a new slayer pro I speak of. Thanks, just curious...
  8. Replies
    1
    Views
    273

    Slayer pro servo rate limiting

    Any way to rate limit the servos on a slayer pro with a TQ radio?
  9. Strange, nothing bent or broken. the upper...

    Strange, nothing bent or broken. the upper suspension arm ball popped out of its socket on the axle carrier. I was able to put it back together and continue running fine (albeit now I need to touch...
  10. Ok nevermind, i got everything installed and it...

    Ok nevermind, i got everything installed and it worked out well. Thanks for everyone's input. If it wasn't for that curb that got in my way and knocked my upper A arm out of its socket, it would have...
  11. ok guys, i have all the parts and I'm preparing...

    ok guys, i have all the parts and I'm preparing to sit down and work on it but before hand I read in the instructions that came with the rear brake kit that chassis modification may be required. Do...
  12. Ok I'm diving in then!

    Ok I'm diving in then!
  13. Ok confusion ensues....the brake kit says it's...

    Ok confusion ensues....the brake kit says it's for the revo. And when I ask traxxas customer support, they say no, neither that nor the center diff will work on my car. So I'm lost...?
  14. Brand new Slayer Pro 3.3 TQ #25 MJ edition Nitro truck / compatible accessories?

    Hello,

    I just picked up a new #25 Mark Jenkins edition Slayer Pro 4x4 TQ nitro truck with the 3.3 engine. Question.....can the following be added to this truck?:

    1.> sway bars
    2.> rear brake...
Results 1 to 14 of 14