Search:

Type: Posts; User: ImRustlin

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Thread: wheelie bar

    by ImRustlin
    Replies
    14
    Views
    1,687

    I plan to put heavier grease in the diff next...

    I plan to put heavier grease in the diff next time the tranny falls apart. thats a beautiful rustler you have there.
  2. Thread: wheelie bar

    by ImRustlin
    Replies
    14
    Views
    1,687

    I know integy sucks but I liked the upgraded...

    I know integy sucks but I liked the upgraded battery box. I just bash so I'll go with the tbone, thanks again powerman
  3. Thread: Brake disc

    by ImRustlin
    Replies
    8
    Views
    1,125

    ordered, thanks powerman

    ordered, thanks powerman
  4. Thread: wheelie bar

    by ImRustlin
    Replies
    14
    Views
    1,687

    is the integy wheelie bar a replacement for the...

    is the integy wheelie bar a replacement for the battery box in the back?
  5. Thread: Brake disc

    by ImRustlin
    Replies
    8
    Views
    1,125

    How did the slash brake work for you? I am...

    How did the slash brake work for you? I am running into the same problem with my 3.3 Rustler
  6. Replies
    3
    Views
    443

    Nitro Rustler Back to Life

    This is the story of my second Nitro Rustler. Perhaps I will tell the story of the first another time.

    This is an unhealthy battery.
    http://imageshack.us/a/img853/1382/imageovp.jpg

    This is...
  7. Replies
    7
    Views
    535

    My gap is correct. I did notice that when I hold...

    My gap is correct. I did notice that when I hold the brake the bearings still spin. Does that have to do with the clutch shoes being bad? Also when I lift the back wheels off the ground they speed up...
  8. Replies
    7
    Views
    535

    Thanks for the reply. I adjusted the linkage and...

    Thanks for the reply. I adjusted the linkage and made it tighter. It helps a little but, it still won't stay still. At first it is still then slowly it begins to creep forward and if I don't hit...
  9. Replies
    7
    Views
    535

    Rustler will not stay still please help

    So my rustler will not stay still in idle and I have done everything, I think. I started from the top, adjusting hsn then went to Lsn then went to idle screw. Rusty would still roll forward without...
  10. Replies
    0
    Views
    304

    Throttle Return Spring

    I'm having trouble finding a good solution for my throttle return spring. Should I use a spring or rubber band and how should I install it?:confused: I have tried with rubber bands and springs but,...
  11. Replies
    4
    Views
    584

    I destroyed my lower chassis so I was wondering...

    I destroyed my lower chassis so I was wondering if upgrading to a RD Racing one would be better. It is listed under nitro rustler.
  12. Replies
    4
    Views
    584

    RD Racing Upper and Lower Chassis

    I need a new upper and lower chassis. Was thinking about upgrading to RD Racing. I have heard there parts are great but, will it be a perfect replacement for the stock parts. I want to make sure...
  13. Does it idle fine when the wheels are on the...

    Does it idle fine when the wheels are on the ground?
  14. Replies
    3
    Views
    476

    I bought a servo extender at my LHS was 4$ it...

    I bought a servo extender at my LHS was 4$ it looks like it will work just fine. I have some electrical tape I will use to make sure it doesn't disconnect while driving. Looks much better than my...
  15. ^that's wrong

    ^that's wrong
  16. Replies
    3
    Views
    476

    Thank you forthe tip and reply. I bought some...

    Thank you forthe tip and reply. I bought some wire. I cut and connected it with tape. Seems to work fine but not sure how it will hold up when I start bashing it. Motto mention what an eye sore it...
  17. Thread: stalling

    by ImRustlin
    Replies
    2
    Views
    250

    It's not great to run it in too cold of weather....

    It's not great to run it in too cold of weather. Could be stalling at high speeds if the fuel mixture is too lean
  18. Replies
    3
    Views
    476

    Receiver Harness Question

    I have the Traxxas receiver harness (tra3034) on my rustler and it barely reaches my mini receiver (tra2218x) incased in a receiver box installed in the front. Anyone know of a longer harness or any...
  19. Replies
    5
    Views
    383

    Ok thank you, looks like I have a project this...

    Ok thank you, looks like I have a project this holiday weekend
  20. Replies
    5
    Views
    383

    Will a rebuild fix the air leak? I don't know how...

    Will a rebuild fix the air leak? I don't know how to find exactly where the leak is or how to stop it. Would a new engine be an option, maybe a 3.3?
  21. Replies
    5
    Views
    383

    Still Struggling

    :confused:

    My Rustler still won't start up. I had a thread, but I guess it got deleted :/

    I took the cooling head off and I discovered a missing piece, but I'm not sure if this is the problem...
  22. Replies
    9
    Views
    754

    I bought the fuel in July, so that's good. And i...

    I bought the fuel in July, so that's good. And i really flushed the carb filled it up with brake cleaner. When i used the easy start to flush the fluid through i could see some shooting out the front...
  23. Replies
    9
    Views
    754

    I took the line out and checked it but I didn't...

    I took the line out and checked it but I didn't see any holes and I see fuel going through when I prime it.
  24. Replies
    9
    Views
    754

    Put in a brand new plug and still nothing :( I...

    Put in a brand new plug and still nothing :( I recorded a video of it so you guys could hear the sound it's making, it doesn't sound quite right.

    http://www.youtube.com/watch?v=IRGsPwV7vWY
    ...
  25. Replies
    9
    Views
    754

    glow plug works and batteries are charged, i...

    glow plug works and batteries are charged, i don't have a temp gauge and don't know how to check engine compression, but it does turn over and sounds like it wants to start.
Results 1 to 25 of 28
Page 1 of 2 1 2