Search:

Type: Posts; User: cadmanslayer46

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    9
    Views
    495

    I would say any engine that has exact same...

    I would say any engine that has exact same dimensions as a Traxxas 2.5/3.3 backplate, and providing you have room on said car or truck for ezstart components....
  2. Replies
    4
    Views
    638

    oh yes, less oxygen equals less fuel need, here...

    oh yes, less oxygen equals less fuel need, here close to sea level, winter dry air i need over 4, summer heavy humid air,3.5 or so.....
  3. Replies
    10
    Views
    1,769

    Man, you can buy a 3.3 in pieces off ebay for 80...

    Man, you can buy a 3.3 in pieces off ebay for 80 to 110, depending if you buy back plate, and starter shaft or not! Put it together and Voila, you have an engine.....
  4. Replies
    10
    Views
    1,769

    Not so I can tell it, I had some bearing issues a...

    Not so I can tell it, I had some bearing issues a few years ago, but now i just think i was always running a tad lean, just make sure of your temps, do maintenance, and enjoy, some guys on here were...
  5. +1 what Al said, bearings dont last forever,...

    +1 what Al said, bearings dont last forever, diffs dont either, maintenance, is the key to longevity Grasshoppa!
  6. Replies
    4
    Views
    694

    Diffs are stamped "Revo Up", goes towards...

    Diffs are stamped "Revo Up", goes towards chassis.......
  7. Replies
    5
    Views
    506

    nitro fuel doesnt taste good!!!!!!

    nitro fuel doesnt taste good!!!!!!
  8. Replies
    22
    Views
    626

    as long as you are not Chuck Norris blowing, to...

    as long as you are not Chuck Norris blowing, to qualify that statement...
  9. Replies
    22
    Views
    626

    yep, new o-ring time for sure!!!!! easy peazy...

    yep, new o-ring time for sure!!!!! easy peazy lemon squeazy fix!!
  10. Replies
    5
    Views
    506

    I ALWAYS prime before start with pressure line...

    I ALWAYS prime before start with pressure line off of pipe, with a pull start thats the most logical way to go about it.....fuel line length is for rollover running, i have seen guys not use it, with...
  11. Replies
    14
    Views
    1,176

    Well, I usually dont like being Captain Obvious,...

    Well, I usually dont like being Captain Obvious, so my posts are usually to the point, but just in case you didnt know, make sure you do a thorough check of bearings in diffs as well,lol.....
  12. Replies
    4
    Views
    637

    Even in summer, a blow dryer or heat gun works...

    Even in summer, a blow dryer or heat gun works wonders to alleviate the dreaded TDC stick issue, it hurts my feelings when i know my brand new engines piston is sticking in my brand new sleeve, so I...
  13. Replies
    14
    Views
    1,176

    YEAH,I didnt mean that upgrading internals would...

    YEAH,I didnt mean that upgrading internals would fix outer case wear,lol, all my diffs have a certain amount of that scrubbed look......
  14. Replies
    14
    Views
    1,176

    Look up the exploded views of the E-Revo diffs,...

    Look up the exploded views of the E-Revo diffs, and use those parts to rebuild your diffs, you will never have anymore diff issues!
  15. get Hsn dialed in, then get lsn dialed in, 3.3...

    get Hsn dialed in, then get lsn dialed in, 3.3 will scream then, many sites, and youtube vids, on tuning, start with Traxxas factory specs, and go from there. BUT, getting it all together HSN,with...
  16. most important thing, is get a good seal, without...

    most important thing, is get a good seal, without overtorquing them, alot of guys have a heavy hand, and thing it needs to be baby Gorilla tight, when it doesnt!!!
  17. Replies
    22
    Views
    626

    did you put the clutch spring together, or did an...

    did you put the clutch spring together, or did an lhs tech? Sometimes I have had trouble, getting clutch springs to stay together....
  18. Replies
    3
    Views
    604

    sounds like it leans out too much, do your tune...

    sounds like it leans out too much, do your tune with half a tank, and try that, barring air leaks,etc, that sounds like your issue...
  19. Replies
    22
    Views
    626

    pop carb 0ff, take out hsn, spray or blow through...

    pop carb 0ff, take out hsn, spray or blow through port, should take care of it, thats not abnormal, after setting up for a while
    reinstall hsn then blow through fuel inlet by mouth should be hard...
  20. Replies
    3
    Views
    429

    There is a huge newly graded construction site...

    There is a huge newly graded construction site near here, with terraces, nice piles of dirt here and there, easy ingress, and egress. yesterday, it was dry, and just waiting, today, its muddy and...
  21. Replies
    3
    Views
    429

    Force Field?

    How do you build a moving force field, that extends out 75 feet in all directions around you, and your Revo. It has to repel rain, dry up mud, while letting breeze, and sun in. Must not interfere...
  22. I dont know because I have never upgraded to 2.4...

    I dont know because I have never upgraded to 2.4 yet,lol, I just posted here because this thread looked lonely, as far as the servo goes, sounds like just a bad servo...
  23. Replies
    3
    Views
    542

    It,ll take dew laden grass, light drizzle, and...

    It,ll take dew laden grass, light drizzle, and some snow running, just keep water off of the air filter, and radio gear, unless you balloon, or seal up radio box good. In a nutshell, water and any...
  24. Replies
    1
    Views
    474

    The flyweights would have to be broken,to be...

    The flyweights would have to be broken,to be stuck in second gear, in a flung out position, which seems far fetched to imagine, thats one part i have never had to replace, is the shift mechanism....
  25. Replies
    12
    Views
    847

    yes, no link though, I got two used from my LHS,...

    yes, no link though, I got two used from my LHS, for ten bucks, I got lucky, I think it is the Proline Crowd Pleaser body though....Its protects everything nicely, and I bash hard!!!!!
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4