Search:

Type: Posts; User: GForce

Page 1 of 8 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    47
    Views
    1,579

    Try the small screw driver from Dremel. Also...

    Try the small screw driver from Dremel. Also comes with cordless high speed Dremel rotary tools we like so much. The nice part about the Dremel is it is variable, small, charge last forever and the...
  2. Replies
    3
    Views
    508

    Done a bit of quarter mile racing with my ERBE....

    Done a bit of quarter mile racing with my ERBE. Usually the track is 132 feet (1/10th a quarter).

    The problem you find is rear wheel stands. I finally finished with 39.96mph using 54/18. I would...
  3. Thread: I'm stumped..

    by GForce
    Replies
    18
    Views
    634

    The stub axle and bearing are made to a slip fit....

    The stub axle and bearing are made to a slip fit. Any wear will cause an uneven surface on the stub axle thus making it difficult to remove and reinstall.

    Like those before mentioned use a small...
  4. Replies
    30
    Views
    788

    Remember we will always chase the mystical...

    Remember we will always chase the mystical perfect setup and no two are alike leaving the ultimate control to the driver!

    Hope to hear from your track visit.
  5. Replies
    30
    Views
    788

    MTPOCKETS I had the very same problem and I think...

    MTPOCKETS I had the very same problem and I think mostly it comes from the nitro truck to the brushless. They are so different to drive. Tim Roberts is over on Revo-world.com and offers the same...
  6. Replies
    25
    Views
    1,051

    Being this is a survey not an opinion poll.......

    Being this is a survey not an opinion poll....
    Silver - front
    BLue - rear
    #3 VD - all
    50w - all
    Ride height - 45 - 50 mm
    Rear sway heavy
    LRP Hole shots
  7. Replies
    39
    Views
    1,055

    Can we say hi-jack!!:eek: Running 18/56 thats...

    Can we say hi-jack!!:eek:

    Running 18/56 thats 3.11:1 SMC 2S batteries 5200 mah rated 40C. Temps fine. Run time 17 minutes hard racing 22 minutes cruising.
  8. Replies
    24
    Views
    3,296

    Recently racing 1/4 mile I was able to shut the...

    Recently racing 1/4 mile I was able to shut the other lane down by using the slipper to my advantage. The brushless truggy I was up against went about 1/3 of the track when the front end shot skyward...
  9. Replies
    23
    Views
    629

    Ran my ERBE on NiMH batteries for a month before...

    Ran my ERBE on NiMH batteries for a month before I finally bought the Lipos. Truck is slower and heavier. NiMH just don't have the current available as a good 28C lipo does. I use them as back ups...
  10. Thread: Summit Axles

    by GForce
    Replies
    16
    Views
    1,113

    8ight-e question? Can't you set the punch...

    8ight-e question?
    Can't you set the punch control down a bit on those high bite tracks? That would help reduce driveline breakage. Of course set the slipper as well.
    Even a real highway rig will...
  11. Replies
    5
    Views
    350

    Sold all my nitro and went to electric because:...

    Sold all my nitro and went to electric because:
    1.) the Slash is bullet proof and cost effective
    2.) The Revo brushless came out.
    3.) The cost of nitro is going through the roof.

    Other benefits...
  12. Thread: Disappointed

    by GForce
    Replies
    18
    Views
    400

    Buy an ERBE!:)

    Buy an ERBE!:)
  13. Thread: Race run time

    by GForce
    Replies
    7
    Views
    372

    Race run time

    What are your average race run times and what are you using to obtain it?

    My set up is 4S 5000Mah/ 40C. Gearing 18/58 = true track time 19 to 21 minutes.

    I would like to acheave a 30 min main...
  14. Replies
    17
    Views
    573

    If he put that low of oil in it wouldn't you get...

    If he put that low of oil in it wouldn't you get excessive front wheel spin and no wheelies!:wacko:
  15. Replies
    14
    Views
    768

    Got them from my local hobby store in Calgary...

    Got them from my local hobby store in Calgary Alberta, Canada. PM Hobby Craft. The batteries have worked great and have a 40C rating!
  16. Replies
    14
    Views
    768

    You might try SMC C-MAX 7.4, 5200 mAh / 40C They...

    You might try SMC C-MAX 7.4, 5200 mAh / 40C They work great for me.:wub:
  17. When rebuilding my Revos, nitro or electric, I...

    When rebuilding my Revos, nitro or electric, I have been using engine RTV sealer. Place a good size amount into the bottom and then install the differential and bolt it together. Let set overnight....
  18. Thread: Problemo!!

    by GForce
    Replies
    19
    Views
    541

    Hey how long is this piece of string I am holding...

    Hey how long is this piece of string I am holding up? Too funny!:lol:

    Take those fancy exploded pics and photocopy onto double sides sheets and plastic coat them. Then put them in your tool box....
  19. Replies
    12
    Views
    585

    Hey UBERBRICKY42 see you at the RCGears season...

    Hey UBERBRICKY42 see you at the RCGears season opener!?
  20. Replies
    6
    Views
    787

    Titanium are stronger and lighter but will snap....

    Titanium are stronger and lighter but will snap. The original steel work just fine for the casual racer or basher that just might find a bad landing or three.:(
  21. Replies
    72
    Views
    1,559

    We need a sign. Similar to the one guys sig on...

    We need a sign. Similar to the one guys sig on here. It goes like this

    Its electric.
    About 20 minutes.
    At least 30 mph stock.
    Too far.
    No you can't.

    All questions are answered by these very...
  22. Replies
    16
    Views
    542

    Is it less one way or both ways?

    Is it less one way or both ways?
  23. I make a one way for the tranny. It takes place...

    I make a one way for the tranny. It takes place of the CD and gives you all wheel braking. Make it for both the regular tranny and the rear brake set up. It removes the issue of changing diff oils...
  24. Replies
    21
    Views
    460

    It use to be the Canadian Winter Nationals was...

    It use to be the Canadian Winter Nationals was all in one building. Now they are in two seperate buildings that are joined by a walk through. That has allowed them to have a clearer but cooler race...
  25. Replies
    21
    Views
    460

    Check out Youtube for the previous years.:)

    Check out Youtube for the previous years.:)
Results 1 to 25 of 194
Page 1 of 8 1 2 3 4