Search:

Type: Posts; User: Zigga

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. Replies
    4
    Views
    532

    I concur. The promotional video only shows the...

    I concur. The promotional video only shows the Alias getting run over by a bicycle, not a car. There is likely something broken on the receiver board that is not visible.

    DollarHobbyz.com used...
  2. Replies
    138
    Views
    15,416

    I believe just about everyone here is using the...

    I believe just about everyone here is using the standard LaTrax transmitter. For me, it is comfortable, configurable, and provides instant access to any accessories that I attach to the quad...
  3. Replies
    55
    Views
    12,778

    Sticky: Alias stunt flying in expert mode, captured with...

    Alias stunt flying in expert mode, captured with two cameras. Watch it in full screen and crank up the volume. :)


    http://youtu.be/-voOR8q087U
  4. Replies
    138
    Views
    15,416

    That is a very nice, all-inclusive package. My...

    That is a very nice, all-inclusive package. My one concern is that, because of the configuration of the camera/transmitter/antenna combo, you will need to mount it to the top of your Alias. So in...
  5. Replies
    9
    Views
    1,805

    Your suggestions sound great, but far beyond my...

    Your suggestions sound great, but far beyond my expertise to implement. I would have no idea how to make any of that happen. The only solution I have come up with is to use the Alias camera for...
  6. Replies
    11
    Views
    585

    I have noticed a big drop in flight times when I...

    I have noticed a big drop in flight times when I fly in colder temps (around freezing). I have also found that if I keep the batteries in my pocket until I am ready to plug them into the quad helps...
  7. Replies
    138
    Views
    15,416

    I just shot a new video using the Alias camera...

    I just shot a new video using the Alias camera for recording and my RMRC camera/transmitter combo for FPV. The quad was a little heavy with all that but still performed pretty well. Check it out.
    ...
  8. Replies
    138
    Views
    15,416

    I purchased an Alias clone recently. It was 1/3...

    I purchased an Alias clone recently. It was 1/3 the cost of an Alias, but about 1/3 the quality too. I posted a review of it here,...
  9. Replies
    10
    Views
    2,169

    Love your stories, noir. You have a gift. ...

    Love your stories, noir. You have a gift.

    Your battery-signal-locator-technique sounds feasible. I'll have to try that out. A buddy of mine just recently lost his Hubsan X4 when we were out...
  10. Replies
    138
    Views
    15,416

    Hi there, down in Middle Earth land. Your list...

    Hi there, down in Middle Earth land. Your list appears complete, and although the FPV combo from RMRC with the windmill antenna works well enough, the TX5805 camera/transmitter combo for the...
  11. Replies
    138
    Views
    15,416

    Great story, Noir. Felt like I was there with...

    Great story, Noir. Felt like I was there with you. It's a great feeling flying this thing from the cockpit.

    I'm still using the cheapo $4 motors from Banggood in my FPV Alias. Haven't bothered...
  12. Replies
    138
    Views
    15,416

    Yes, it does look very nice. I can foresee a...

    Yes, it does look very nice. I can foresee a potential problem though. When the Alias has a hard landing and the antenna comes loose from the transmitter, are you able to easily reattach it or do...
  13. Replies
    138
    Views
    15,416

    That stinks about the glue going everywhere. ...

    That stinks about the glue going everywhere. Lesson learned for us all. Thank you. :)

    Tape gooeyness might be an issue in Texas. Not so much up here in New Hampshire. Go with whatever works....
  14. Replies
    138
    Views
    15,416

    I'm tellin' ya, a little bit of electrical tape...

    I'm tellin' ya, a little bit of electrical tape works well for holding stuff onto the Alias and it's lightweight. I haven't had any problems with ground clearance either.

    If you are able to stick...
  15. Replies
    138
    Views
    15,416

    Nice job on the rebuild. I see you're making use...

    Nice job on the rebuild. I see you're making use of the 3D printed undercarriage. How's that work out? I might like to get one.

    That's too bad about losing your clover antenna. Really stinks. ...
  16. Replies
    9
    Views
    1,805

    I think it's been concluded that there is no...

    I think it's been concluded that there is no video feed from the Alias camera's circuit board that can be tapped into. Too bad. Would have been nice to transmit FPV video from the same camera that...
  17. Replies
    138
    Views
    15,416

    I believe that is correct about the lower...

    I believe that is correct about the lower frequency transmitters requiring more power to run them. The 5.8ghz system has a few things going for it: Lightweight, very small, can be run off of the...
  18. Replies
    138
    Views
    15,416

    Nice test run. Was that a triple flip you were...

    Nice test run. Was that a triple flip you were attempting? The FPV components are lightweight but they do dampen the recovery after doing tricks. That being said, I would strongly recommend doing...
  19. Replies
    138
    Views
    15,416

    Mr. Clean, That is a great looking rig. Looks...

    Mr. Clean,

    That is a great looking rig. Looks like you've got some vibration dampening foam in there too. You may find that it is not necessary since this system is only broadcasting low-res...
  20. Replies
    138
    Views
    15,416

    Well, at least that's a hopeful response. I hope...

    Well, at least that's a hopeful response. I hope your goggles come in soon as well.
  21. Replies
    138
    Views
    15,416

    Check out the description (About) under my new...

    Check out the description (About) under my new video. There are links to a couple other places that sell the same Altitude transmitter and they have it in stock and at the same price.
  22. Replies
    138
    Views
    15,416

    Do I understand that you ordered the FPV combo...

    Do I understand that you ordered the FPV combo package from RMRC? Did they give you any idea as to when it might ship, as they currently seem to be out of stock? They still have most of the...
  23. Replies
    138
    Views
    15,416

    If anyone is interested, I just created a "How...

    If anyone is interested, I just created a "How to" video on how I put together my FPV Alias.


    http://youtu.be/-c7CnmFJP4s
  24. Replies
    9
    Views
    1,805

    Yeah, the VCC turned out to be power. Wasn't...

    Yeah, the VCC turned out to be power. Wasn't able to find a way to do what I was trying for. Thank you all for your input.
  25. Replies
    138
    Views
    15,416

    Hey Mr Clean, Thank you for your comments and...

    Hey Mr Clean, Thank you for your comments and interest in this project.

    I went with, and would recommend going with the pico camera. There's probably no huge difference between the pico and mini...
Results 1 to 25 of 43
Page 1 of 2 1 2