Search:

Type: Posts; User: Propwash

Search: Search took 0.01 seconds.

  1. Replies
    7
    Views
    602

    Thanks guys; I found the plate and got everything...

    Thanks guys; I found the plate and got everything mounted including a king headz mount. I plan to shorten the wires too but for RTR for now. (My receiver came with cut wire turned out - once I get it...
  2. Replies
    7
    Views
    602

    Thanks. I will recheck the box. It's the SC8. Is...

    Thanks. I will recheck the box. It's the SC8. Is it attached to the esc? Like I mentioned I noticed 2 holes (and they lined up with the chassis) but it appeared to actually be the case itself and not...
  3. Replies
    7
    Views
    602

    ESC mounting suggestions

    Hi all. New to the slash but not RC question on mounting a 1/8 scale hobbywing esc to the slash LCG chassis. I normally would servo tape it but with the honeycomb bottom I do not feel it will hold. ...
  4. Suggested pinion for 4000V HW motor with stock spur?

    Hi all, I am adding a HW EZRUN WP-SC8 ESC and 4000KV motor to my Slash 4x4 Ultimate and I am looking for advice on gearing. I have the stock 13/54 gearing now on a Velineon setup now. Thoughts? Will...
  5. Replies
    14
    Views
    826

    Do you race? If not save the center diff. There...

    Do you race? If not save the center diff. There is a reason it's not in there when you buy it. The slipper clutch is more durable and better for bashing. Saves your driveline. It will burn up if...
  6. Replies
    19
    Views
    1,177

    I have this question with regard to gearing if...

    I have this question with regard to gearing if going from 2.2 to 2.8 tires. I am stock slash gearing now (13/54)... Any ideas on gearing for 2.8 tires or should this be ok? I plan to put on my...
Results 1 to 6 of 6