Search:

Type: Posts; User: Themader346

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    113

    setting rustler spur gear

    Hi everyone my spur gear on my rustler always has a tiny bit of wobble to it even after ive re done it several times it always has that wobble. The shaft into the transmission isnt bent and the...
  2. Replies
    5
    Views
    780

    Right wheel spinning faster than left

    Hi everyone. I've recently noticed with my rustler vxl that if I hold the front end with my foot and spin the tires with the throttle that the right one is fine but the left barely spins at all. I'm...
  3. Thread: Lipo

    by Themader346
    Replies
    6
    Views
    157

    Ok does it fit into the battery tray without any...

    Ok does it fit into the battery tray without any modification?
  4. Thread: Lipo

    by Themader346
    Replies
    6
    Views
    157

    Lipo

    Hi everyone. I am thinking about upgrading to a lipo battery for my rustler vxl. If I do upgrade I will get a 2s battery because I already have a cheap 2 s charger that I use with a rtf plane. The...
  5. Replies
    5
    Views
    274

    Ok it's just a tiny bit that's melted and I've...

    Ok it's just a tiny bit that's melted and I've covered it with black tape so I don't know if that will help
  6. Replies
    5
    Views
    274

    Nimh battery melting

    My rustler vxl is starting to melt the case of my stock battery pack. I just ordered different opinions and I'm not sure whether gearing down will help or I might just ditch the stock pack and go to...
  7. Thread: sugestions

    by Themader346
    Replies
    7
    Views
    135

    Yes the rustler is great I recommend getting the...

    Yes the rustler is great I recommend getting the rpm front bumper and probably go ahead and order rpm front and back a arms. I've had my rustler vxl for 6 months and the only thing I've broken is one...
  8. Replies
    8
    Views
    231

    If you can pick up the back end of the truck and...

    If you can pick up the back end of the truck and the wheels spin some with throttle but not on the ground it is probably a broken roll pin that holds on the top drive gear in the transmission. You...
  9. Replies
    1
    Views
    129

    Never mind I got it off thanks

    Never mind I got it off thanks
  10. Replies
    1
    Views
    129

    Pinion stuck

    I'm trying to remove the stock pinion gear on my rustler vxl. I took a pair of pliers and grabbed behind the gear and on the shaft and I've pulled it to the end of the shaft. Now that there is...
  11. Replies
    17
    Views
    234

    Are you sure the hexes are clicked onto the pins?...

    Are you sure the hexes are clicked onto the pins? I've never had a problem with them falling out
  12. Replies
    6
    Views
    249

    Yes cut a small piece of a 1/16 inch drill bit to...

    Yes cut a small piece of a 1/16 inch drill bit to use. I did that to mine and haven't had any problems
  13. Replies
    18
    Views
    393

    Overheating

    My rustler vxl has been recently getting hot on stock gearing and battery. I usually run in grass and dirt and have to quit after about 5-10 minutes to let it cool. I dont know if its because the...
  14. New tranny case is what you need

    New tranny case is what you need
  15. Replies
    11
    Views
    294

    Take the shocks apart and put the spacers in...

    Take the shocks apart and put the spacers in them. This will lower your truck a little not sure how much
  16. Replies
    10
    Views
    258

    That's cool it's be awesome if you had an action...

    That's cool it's be awesome if you had an action figure of Phil with a working steering wheel
  17. Replies
    11
    Views
    414

    You will probably want rpm a arms and shock towers

    You will probably want rpm a arms and shock towers
  18. Replies
    12
    Views
    343

    I don't want to drill anymore because I know I'm...

    I don't want to drill anymore because I know I'm at the shaft. I went real easy at the end and when I tap the shaft it sparks and I'm afraid of damaging the shaft
  19. Replies
    12
    Views
    343

    I tried the hex driver from the duratrax tool kit...

    I tried the hex driver from the duratrax tool kit and all it did was strip it. I tried using a star head driver. But that just dripped it more. So then I tried drilling and the screw is completely...
  20. Replies
    10
    Views
    1,215

    I never thought of that I've had my rusty for 2...

    I never thought of that I've had my rusty for 2 months and already have rpm shocktowers and a arms
  21. Replies
    0
    Views
    48

    Motor testing

    I was wondering if I could take my rustler vxl and put a cheap motor on it like a ******* ********* 1/10 just to screw around with to see what it can do.
  22. Replies
    10
    Views
    1,215

    Wow I wish I had the money right now to do this...

    Wow I wish I had the money right now to do this haha
  23. Replies
    12
    Views
    343

    What ever the stock pinion is that comes on...

    What ever the stock pinion is that comes on current rustler vxl and I have stock spur 76t spur and 90t spur
  24. Replies
    12
    Views
    343

    I tried to drill out the screw but the gear is...

    I tried to drill out the screw but the gear is still stuck of the shaft
  25. Replies
    12
    Views
    343

    Lipo gearing rustler vxl

    Hi I was wondering which spur gear to use for 2s lipo on a rustler vxl. I can't change the pinion because it is stuck on the shaft
Results 1 to 25 of 33
Page 1 of 2 1 2