Search:

Type: Posts; User: steverogers9486

Search: Search took 0.01 seconds.

  1. First run with the rustler with mamba max pro and castle 4600kv freaking awesome

    I ran the rustler with the combo today with 25/83 gearing on a 35c 3s lipo and the thing ran cool as anything. I have a heatsink with fan on the motor as well. The rustler is my street car as I have...
  2. I also have a mamba monster for my emaxx...

    I also have a mamba monster for my emaxx brushless that would do this also until i downgraded it to firmware 1.24 and it was gone. the mamba max pro on 1.24 still does it so i put it back to 1.26 and...
  3. issue with mamba max pro 4600kv in rustler

    Ok i just installed this thing and i am getting like a small punch at low speeds. like for example, if i am giving it 10% throttle, it will start moving and then jump into a slightly higher speed. I...
  4. To those with a mamba max pro esc and a 3800, 4600, 5700kv motor in thier rustler

    What settings did do in the castle link software. I have read to keep the firmware on 1.26 but what about everything else like timing, punch, etc. I dont care about brake and throttle curves.. I...
  5. Replies
    9
    Views
    666

    now how much of a pain is it to remove the screw...

    now how much of a pain is it to remove the screw once you use red loctite on it? The hex screws strip to easy
  6. Replies
    9
    Views
    666

    What do you loctite

    Ok so my stupid self didnt loctite the screw on the center drive shalf and today i lost both front cups and shaft. Rear was bearly hanging on.. I have the flm chassis with flm shafts. I ordered new...
  7. Replies
    10
    Views
    644

    most of the negative comments about this truck...

    most of the negative comments about this truck are the people who expect it to jump off a cliff and land without breaking. Any RC car is gonna break when you bashing the crap out of it. The castle...
  8. yes are you running trencher tires or big joes...

    yes are you running trencher tires or big joes etc? also do you have some added weight from the flm parts?
  9. i dont even care if the truck only get 40mph.. i...

    i dont even care if the truck only get 40mph.. i just want something to keep the combo cool
  10. they are 5000mah. I have both 4 and 6S setups

    they are 5000mah. I have both 4 and 6S setups
  11. Whats your gearing for you maxx with Alum chassis, towers, etc with trencher tires

    With the weather getting better, it time to get the maxx back out on the road. Over the winter i did a lot of upgrades. FLM chassis, shock towers, hubs, new steel drive lines, rpm a arms and trencher...
Results 1 to 11 of 11