Type: Posts; User: Z32turboR1
will either of these two engines a direct fit in to the revo 3.3?
I've never taken a tranny apart, this is my first RC and i purchased it in dec of last year. it does still have reverse and stock plastic gears. If i have to take the tranny apart to service it...
yeah most of the time when i come to a complete stop it wont' shift back down to first and when i start off again it's in second, sometimes it shifts back down to first.
The truck is only shifting back down to first 50% of the time or less.
What could be causing this issue?
Could it be something broken in my transmission?
The truck runs under 240 at wot, and...
what is the sleeve mod?
wasn't me i didn't bid on it =)
they should move, the paper should go in and come out with teeth marks but not rip.
it's on the driver side of the vehicle under the air filter in that box. the bigger servo the smaller one is your reverse if you have it.
where did you get that skid and where did you order the rears? can you pm me with a link to their site
It goes on the crankshaft before the flywheel. Then you slide the flywheel over it and should be tight once you tighten down the flywheel nut.
Increase in rpm for 3-4s then dies
So I finally get my new motor broken in, and it seems to be idling high.
What can be the cause of the high idle.
I tried adjusting the idle screw if I close it some the temp rises or...
the fuel line that we use on the truck?
not sure if you need it on a jl but did you put on a http://buy.traxxas.com/product_info.php?cPath=11449_7833_6959&products_id=5625
that looks like the back tire that he broke the carriers on, if that was broken to begin with while you were showing him the truck the back tire would have been wobbling all over the place or turning...
Yep that's the thread
I have the strc p2 rockers and lundsford p2 titanium pushrods
I recently put in gtr shocks in to my revo, and even at the lowest setting the back is higher than the front (fronts set at highest settings) I'm running 80wt oil and black springs (5.4 rate I think)...
I kept my ez start on mine and just use a glow plug igniter it works a lot better that way and the battery in the wand last much longer, if you search through the forum there was a post about...
have you checked your idle screw setting?
dynamite has their traxxas starter kit tools for around 30 bucks and so far i haven't had the need for any other tools other than my wheel hex and pair of needle nose.
5318x is for use with long travel rockers #5356 and 5319x is for use with progressive 3 rockers #5359.
the revo comes i believe with progressive 2 rockers.
those are some awesome pics!! i'm jealous wish i had snow like that to run my revo through. very clean nice truck! i wish my tires and wheels look that nice they are pretty beat up lol
I haven't broken any bolt on headers but I've only had the truck for a month now lol but I did smoosh one side down pretty bad from over tightening. I figure header is 20 bucks and I got a ths pipe...
i need to go get some of that stuff, been hosing off the revo and some screws are starting to rust so replaced those.
where can i get that stuff, sporting good store or walmart?