Type: Posts; User: jfrank05
Where do you get those body clips? Do they work with RPM Towers?
Has anyone ran these with the MIP's. Not sure if they are too thick for the MIP ball joint to move freely as I know the stock ones cause some rubbing.
Or how about the aluminum ones for the...
It's a 4-pole, how do you fix cogging. Do you just need to replace the motor and hope for a good replacement?
Here's the video:
Timing is at the lowest setting, and so is the punch (punch was tested in various positions)
I don't think it's cogging, there isn't any stuttering. Just when the esc senses resistance on the motor it gives up.... It's weird.
Like I said it performs great on flat ground (road or...
I don't think it's the Rx since it runs fine on flat ground. It's almost like the esc shuts the power to the motor down and gives up.
If there is resistance at the start and cant get...
I just purchased a TENSHOCK SC401 V2 (3400kv) and HOBBYWING WATTERPROOF SC8. I run 2S 50C 6500mah batteries.
I noticed when I'm trying to climb over objects or go try and climb up a ramp from a...
The Cage is : http://www.rcplanet.com/ProductDetails.asp?ProductCode=INTT8527&click=109537&gdftrk=gdfV23720_a_7c1734_a_7c7524_a_7cINTT8527&gclid=CJaqztSqgrkCFYKi4Aod9wQApQ
The cage is heavy, mine...
You need a Summit!!!!!
Not to be rude, but I'm always curious how these extreme mods are still considered slashes?
I would reinforce your new body with shoe goo and dry wall tape if you plan on bashing with it. It will get cracked fast and I'd hate to see it get ruined especially since you probably spent a fair...
I just converted mine again last night....they look so sexy.....nicely done.
Actually I think mine is for the stampede.^^^^^^^^^
I believe mine is....its just narrower.
I'm looking for a roll cage to fit on the rally chassis after I did the conversion.
Would the 3400 give more power? Should I go with that one.
I run 2s lipos
Yah I want to keep the cost down. If I wanted to spend close to a few hundred I would definitely grab a CC MMP. What would be a suitable cheaper more powerful motor, I like the esc since its...
I want to have my slash converted to where I can tear up some soccer type fields (mowed but not that low)
Mip's all around
I'm assuming I would need a...
That's what I do. I have done it to two of my bodies. The rear body holes were completely ripped out. I put fiber down then shoe gooed on the under side of the body and on top of the body (tape...
My problem was that its very difficult to have a decent field of vision when it's in the truck when the body is on. I hate running it without the body. So I thought this was the best option.
Its made out of an aluminum bar.
http://s17.postimg.org/hafuqr1v3/DSCN9358.jpg windows 7 screen shot
windows 7 screen shot
I would wait to see if the Dakar body eventually comes unpainted, it seems perfect for what you want.