Type: Posts; User: jdando
Not sure how to do that. It is all weather sealed.
Do I just pull on the three colored wire?
Been a while since I have been active with the RC stuff.
But anyway, was out running the mustang in the stock configuration and it died while running.
Stock everything; Velineon VXL...
Not sure I want to make the jump to lipo batteries. What would be a better (higher mah) battery than the stock 1200mah? Having trouble finding something that would fit? Or what would be some good...
Back after a long absence...batteries barely took a charge, but enough for a quick bash.
Yep, it is the ESP wheelie bar. Assuming I can unscrew the screws it is an easy fix.
Just got done bashing around. Did some jumping with the EMAXX and need to work on my throttle control. Landings ranged from on the front bumper to on it's lid:eek:
Fractured two battery packs...
Looking good. What camera are you shooting?
Late to the thread, but I have a ESP wheelie bar. It is okay!
My rustler has a Swami wheelie bar and it rocks!
They have held up super! Two summers of bashing. This is on my brushless EMAXX, Novak 4400 (the old version of 6.5). I put in the upgraded rotor about a week ago and she runs great!
Yep, you are correct. More searching on the net reveals that they are Dynamite CVD's
Here is the link to the cvd.
Here is the...
Out for a bash today and turned my super duper 4x4 Emaxx into a FWD Emaxx:eek:
I sheared the pin in the CVD.
I just did this with my older Novak 4400 brushless. A good upgrade and relatively cheap at $35.
Start there until you break parts and figure out what is next.
Thanks for your service in the...
Wow I think that has my winter emaxx beat.
Totally waterproofed emaxx with studded tires on a frozen lake
Not sure if it is a fair comparison, but it runs a whole lot better now. I have it geared a little low, so top speed is the same, acceleration is good/better, torque seems good. I can flip it on...
Great, hope it works out for you!
I am not sure/positive, but I think it is basically the rotor magnetic getting demagnitized over time. I am pretty sure that is why the Novak guys came out with the new super fancy rotor as a...
Well cats and kittens, got the new rotor in my "old 4400". And it WORKS GREAT!
It was great to have the truck running again. I also gave an alignment and cleaned it up a bit. Running better...
Hang in there a day or two. I order the rotor and it should be here in a day or two and I will post results ASAP.
Charged packs, no change. Changed packs no change. :(
Talked to the guys at Novak. They said probably the motor rotor is causing the problem.
Said a Novak 5912 is the cure.
Here is the...
Who would have thought my EMAXX would have a glow plug wrench :)
Not the greatest vids. Hard to see the truck, shadows made lighting tough.
Seems like a nice truck.
does anyone have the part number for the wrench so I can get a new one. My old one broke:(
Or if someone has a spare they could sell me that would be great.
Here are a couple of pictures of my Rustler. Perhaps I should have cleaned the body before I took the pictures:o
Here are a...
Out for a bash today and the truck did not run right. Anytime I gave it throttle quickly it stuttered or lost power. If I rolled the throttle on it seemed to work okay. When I flipped...