Search:

Type: Posts; User: MaxxWrecker07

Page 1 of 6 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    16
    Views
    2,774

    Why don't you just trim out the "windows" from...

    Why don't you just trim out the "windows" from the decal... it'll be black underneath and shiny like glass. :D Looks good though!
  2. It's in store credit. Place an order, and they...

    It's in store credit. Place an order, and they take $10 off.
  3. Replies
    16
    Views
    2,774

    I've d-blocked the chassis, save for the green...

    I've d-blocked the chassis, save for the green aluminum rockers I bought that I don't like (and can't send back)... I'd like to go with the red parts as it looks nicer. The traxxas rods are awesome....
  4. Sale Pending to Chris95GT.

    Sale Pending to Chris95GT.
  5. Bumpity bump bump :D

    Bumpity bump bump :D
  6. Bump. Make me an offer.

    Bump. Make me an offer.
  7. FS: Traxxas 1/16 2080 Digital Waterproof Servo

    Up for sale is my new, never used KB Rally servo. This was immediately replaced with another metal gear servo, so it's never been operated. I am asking $20 shipped via PayPal CONUS. Thanks for...
  8. Replies
    3
    Views
    657

    PM sent. :D

    PM sent. :D
  9. Replies
    0
    Views
    857

    Grand National A+ Seller!

    You get a great deal when you buy this guy's stuff. :thumbup:
  10. Replies
    25
    Views
    6,321

    The red light is normal. The wiggle side-to-side...

    The red light is normal. The wiggle side-to-side happens with my car too. I haven't tried to diagnose the cause yet, but it did it before the gyro. I'm going to investigate the knuckles, as I believe...
  11. Replies
    25
    Views
    6,321

    That's the one I have. It works well. As for me...

    That's the one I have. It works well. As for me posting before you... my electrons are faster than yours. :D
  12. Replies
    25
    Views
    6,321

    Yep. I had the same one... failed in a week. I'd...

    Yep. I had the same one... failed in a week. I'd recommend the esky EK2-0704.
  13. OffRoadRC86 is a fantastic buyer! Fast payment and PM responses!

    Sell your stuff to this person!
  14. 1. No 2. No 3. Servo case: Yes Finned heat...

    1. No
    2. No
    3. Servo case: Yes
    Finned heat sink: Maybe
  15. Replies
    12
    Views
    933

    I got the rockers... not so green, unfortunately....

    I got the rockers... not so green, unfortunately. They are quite pale, in fact. Oh well, at least they aren't plastic anymore.
    I actually find myself wishing I could send them back.
    ...
  16. Replies
    14
    Views
    670

    The other issue with squeezing the connectors is...

    The other issue with squeezing the connectors is the lack of electrical contact. When you squeeze them you are only getting two points of contact, rather than the entire circumference. I would be...
  17. Replies
    28
    Views
    2,787

    CM36 motors are 2 pole. The motors that are 4...

    CM36 motors are 2 pole. The motors that are 4 pole are labeled Neu XXXX where x is the appropriate number. A good way to tell is to spin the shaft and feel for "notchiness". A 4 pole unit will be...
  18. Replies
    14
    Views
    670

    White wire on esc goes to the yellow wire on the...

    White wire on esc goes to the yellow wire on the motor. The other two determine the rotational direction. If you pull the trigger and it goes backwards, reverse the two wires. Hope this helps!
  19. Replies
    15
    Views
    1,318

    Reverse Type: With Reverse (*) Brake Amount: 70...

    Reverse Type: With Reverse (*)
    Brake Amount: 70
    Drag Brake: 20
    Punch Control: 60%
    Max Reverse Power: 50
    Arming Time: 1.5 seconds (*)
    Throttle Dead Band: Average (0.1000 ms) (*)
    Motor Type:...
  20. Replies
    28
    Views
    3,761

    Yes, but I found it to be more of an aggravation...

    Yes, but I found it to be more of an aggravation than anything. I have the Castle BEC, which has its output set at 6v, and under full throttle, sometimes the receiver cuts out. I know this is a...
  21. Replies
    15
    Views
    1,318

    You're welcome. I did run the Mamba Max thru the...

    You're welcome. I did run the Mamba Max thru the link, but I can't say what I've set on it. I recently switched out the Mamba for a Sidewinder V2 because of the wire orientation and the price. I'm...
  22. Replies
    10
    Views
    623

    The tie/push rods all have nylon balls. The...

    The tie/push rods all have nylon balls. The machines steel ones replace them. Otherwise, I have no idea what they're talking about....
  23. That's the 1/10 scale summit mount. The 1/16...

    That's the 1/10 scale summit mount. The 1/16 scale mount has another hump on the finned motor mount part.
  24. Replies
    15
    Views
    1,318

    White wire on the ESC goes to the yellow wire on...

    White wire on the ESC goes to the yellow wire on the motor. The other two don't matter. If you pull the trigger and it goes in reverse, change the red and black wires around. :D

    Nice job on the...
  25. Replies
    15
    Views
    1,318

    Here ya go: ...

    Here ya go:

    http://farm6.static.flickr.com/5048/5365652558_d8f7dcf2d4.jpg

    http://farm5.static.flickr.com/4104/5414805736_062c5b4b49.jpg
    ...
Results 1 to 25 of 147
Page 1 of 6 1 2 3 4