Type: Posts; User: mcx1511
its one tough truck. the next thing is parts, for the most part, are very easy to get a hold of. tho some of us have put way to much money into them. they can be run pretty cheap
Racing i run 10K front and 5K in rear work on a short track when steering an issue
qucik why to check for a air leak. if you can get the engine to idle take a fuel bottle and pore gas orund the carb and back plate if the engine dies its because it took in the fuel. under the head...
your question on the bodies. try them. i have everything on mine just see if you like it. some bodies you have to cut more out others follow the lines. running a race truck any one can tell you...
my 18 is the same very sluggish until warmed then screems! never had a rod problem but i also have a max blackplate. this is a bump start motor. torn it down after the series no wear marks on the...
go with a 1400mah battery. racing 30 min mains it sucks when you run out of battery :eek: . your fail safe will kick in and your done! if you run a high speed high torque servo your going to need...
i'll have to agree with myrtleee34. they seem to be the best. i don't bash just race. only have three races on them but there holding up pretty good.
have a question on the mod for the tank what is it? I have to tell you that is one sick ride. good job on the rc pro series!
The Track is in Madera, check out th site
Just an FYI to All REVO in the Centeral Valley, CA. There a Track out in Madera, CA. check out the Site.
For all you traxxas racers there an track out in Madera, CA . So far the REVO are taking names in the novic class. bring yoiu car out!!!
Advertising other message boards is prohibited. - batjerk
Had the same problem with a new revo. there a pin on the main ger of the two speed gear set that back out. stop running it now and open it up before you trash the reset of the gears. or the pin...
racers use the term then the engine dies one the track. most of the time its a vapor lock. A min. or two is it fires back up.
Sounds like your top end is too lean. I'm no expert but i have three of these engines. two work fine one dead. both run around 230 - 250 temp with an outside temp in the upper 90's. I've noticed...
Has anyone tested there TRX 2.5R to see what the compression is? I have one that max 48PSI low of 43psi. tring to find out if its dead or just a bad air leak.
Has Anyone tried a Boost Bottle on there TRX2.5 and could not get your engine to run again? Help to anyone. My Engine will not idle and when i does idle and punch the gas it dies!