Type: Posts; User: MKnAsDad
How about gettiung a price for 2 rotors???
If you like the Axe, check out the Mini as well. Very similar but cheaper and smaller. If you get the Mini or Axe, get the Lurker bolt for it. Only $30. Well worth it. It droped the psi down about 50...
So my Jato has a pull start currently and I am sick of having to take off the body inorder to start the car. Do I need anything other than the EZ Start w/ harness? I already have the starter wand.
I would go a Revo over a Tmaxx personally. I have both and the Tmaxx is delegated to my son.
For only a few $ more, youcan find the one with the ipod dock base. Alot cheaper to upgrade now than later.
Also, you might have to reset the rec/trans to your model.
So the Tmaxx with Integy PB shocks I have for my 8 yr old son, is constantly leaking oil, go figure. My choices are to put stock back on, or get rebuild kit for PB's (Which woiuld cost about $25) or...
Ballpark, what psi can I safely use if I use my compressor to blow it off?
The grey goes to the top one marked yolt/temp, not the red. If you have the correct reciever, you should have an open channel. Plug the red into the open channel.
The black goes into the volt/temp ch, the red goes into any open channel, going by memory. If that doesn't work, reverse the colors.
So my Jato, that I purchased used, is different than the current Jato. On my Jato, the front wheels have a hex in the hub like the back ones. The new wheels are round on the inside. What parts do I...
Can I use my own stuff????
If your fuel tank is not sealing, you will run lean. That might be the problem. My Revo blew the motor because I didn't realize that the tank didn't seal correctly. It blew after about 2-3 tanks...
I assume that he meant kmpg????
Is it a diesel? If not, that is an awful lot of miles on it.
I didn't even think about setting it to the Jato profile. Worked like a charm!!! Thank you!!!
Now just have to go get a glow plug igniter and go rip around with it!!
I am new to the hobby and just got a Jato. It is used and only thing it needed was a receiver and transmitter. I have the TQi for it and am having a problem with the throttle. For the throttle to...
1-On this screen, click "Products" up on the top left
2- On the left side, click on "Nitro"
3- Click on your model
4- Click "Telemetry"
5- It will show the needed parts for your vehicles
I have the Piggybacks on my sons Tmaxx, I am either going to go with the stock ones that I have or order the BB ones. Like stated earlier, they leak.
I would consider just doing a rebuild on the...
either bad servo or bad optidrive.
you can lean it out more, but just watch your temps.
The lack of color means that it is harder to tell the fuel level in the tank.
Only time that 30% is recommended, is when you are racing. 20% is recommened otherwise. I personally haven't used anything other than Traxxas fuel. I have heard that Odonell is not that great. No...
Make sure the fuel clip is not engaged
The magnetic flywheel, RPM sensor and RPM sensor mounting bracket.
Remove engine, remove flywheel from engine, put sensor in correct bracket, mount bracket on left side of vehicle, run wire to...
Brought out my 5310, first real time after the 3.3 powerup. Drove it around for two tankfuls, and couldn't get the truck to stay running for more than 1 second.
I have the 5310 with the TQi receiver. The car runs on 6v. I would like to upgrade to the waterproof, digital servos but nit sure which ones would with with the new receiver. I believe that it has...