Search:

Type: Posts; User: SilverLude

Page 1 of 5 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    9
    Views
    578

    You could run any wheel that used whatever sized...

    You could run any wheel that used whatever sized hexes you put on it.

    https://traxxas.com/forums/showthread.php?8940909-front-spindle-question
  2. Replies
    9
    Views
    578

    You could run any wheel that used whatever sized...

    You could run any wheel that used whatever sized hexes you put on it.
  3. Replies
    9
    Views
    578

    You could also look into a rusty front end...

    You could also look into a rusty front end conversion. Then you will have hex wheels at all 4 corners.
  4. Replies
    31
    Views
    1,234

    Thats what the ez start wand does now.

    Thats what the ez start wand does now.
  5. Thread: t-maxx

    by SilverLude
    Replies
    6
    Views
    192

    But what if his neighbors are those neighbors? ...

    But what if his neighbors are those neighbors?

    In all seriousness, just be respectful no 6 am wakeups and you should be fine.
  6. Replies
    3
    Views
    277

    Not a 100% but it sounds like your engine may be...

    Not a 100% but it sounds like your engine may be shot my friend.
  7. Thread: t-maxx

    by SilverLude
    Replies
    6
    Views
    192

    Not possible. Good luck in your quest though.

    Not possible. Good luck in your quest though.
  8. Replies
    31
    Views
    1,234

    Care to semi elaborate how a speed control will...

    Care to semi elaborate how a speed control will turn an ez start that jump an engine remotely? Just being curious.
  9. Replies
    31
    Views
    1,234

    I wouldn't ditch the ez start too quickly, if...

    I wouldn't ditch the ez start too quickly, if you're new to nitro/breaking in the engine the ez start will save you a workout. You can swap them easily so I would wait and see for yourself.
  10. Replies
    33
    Views
    1,579

    RPM is a good choice for off road. I have them on...

    RPM is a good choice for off road. I have them on my Nitro but my E is stock so I can run the sway bars, lowered shocks and RR's.
  11. Replies
    33
    Views
    1,579

    I've only ran them once on the nitro then they...

    I've only ran them once on the nitro then they went to the e jato but I ran about a tank and a half and I enjoyed them they hooked almost a little too much for where I was running. As far as compound...
  12. Replies
    33
    Views
    1,579

    Its nice when it fires right back up after a tear...

    Its nice when it fires right back up after a tear down. What tires are you running? Anaconda's are notorious for sucking unless drifting is your thing. I personally run SF's when I am pavement only...
  13. Replies
    5
    Views
    268

    1) Yes that is the THS pipe that you're looking...

    1) Yes that is the THS pipe that you're looking for.
    2) As a general rule of thumb, Integy is to be shied away from. Bad QC.
    3)Have you tries adjusting the shift point on top of the transmission?...
  14. Replies
    3
    Views
    208

    If you change your mind about getting a 2.5 lmk.

    If you change your mind about getting a 2.5 lmk.
  15. Replies
    9
    Views
    414

    I usually camp in the fall. I enjoy primitive...

    I usually camp in the fall. I enjoy primitive camping on my aunt in laws property in Tennessee. Mountain camping is seriously fun. I want to try the tents that hang on the side of the mountains but...
  16. Replies
    13
    Views
    1,097

    Looks good man have you found a gear ratio that...

    Looks good man have you found a gear ratio that works yet? I'm almost done with my conversion.
  17. Replies
    23
    Views
    977

    But wouldn't a leak of any kind cause a loss of...

    But wouldn't a leak of any kind cause a loss of compression and wouldnt run at all or run poorly?
  18. Replies
    23
    Views
    977

    http://www.ultimaterc.com/forums/showthread.php?t=...

    http://www.ultimaterc.com/forums/showthread.php?t=94808

    Here is the thread. I keep this flow chart at all times basically this and trial and error helped me learn how to tune.
  19. Just use 3 in 1 oil to re lube it. Should be...

    Just use 3 in 1 oil to re lube it. Should be fine, they are cheap if it is scrap. Disassembly is easy. For the first few times Just take one part off clean it and put it back on then.
  20. Best pipe idk, I haven't tried them all but I'd...

    Best pipe idk, I haven't tried them all but I'd prefer THS over the Traxxas tuned. You can do the rustler front end mod where you can run 12 mm hex wheels at all 4 corners.
  21. Anything? Like cleaner wise? Simple green or...

    Anything? Like cleaner wise? Simple green or purple power are in my top 2.
  22. Replies
    7
    Views
    378

    I second the vote for Badlands.

    I second the vote for Badlands.
  23. I know purple power is simple green should be as...

    I know purple power is simple green should be as well. As long as it doesn't get in the motor and you re lube anywhere there is metal on metal contact you should be good. Letting it sit shouldn't be...
  24. I've always just broke the car down took it apart...

    I've always just broke the car down took it apart and clean piece by piece but I use purple power, I know people that swear by Dawn dishwashing liquid so pick your poison. And yes welcome to the...
  25. Replies
    33
    Views
    1,579

    I run a THS pipe, love it. The 2.5/3.3 Jato is...

    I run a THS pipe, love it. The 2.5/3.3 Jato is all the same, part interchange wise. Maybe the gearing is a tad different never checked that out. Upgrades- I have the single speed conversion in my e...
Results 1 to 25 of 114
Page 1 of 5 1 2 3 4