Type: Posts; User: xm_202_fan
The carb linkage bellcrank goes to far and sticks.. i need to rotate the carb a little so this doesnt happen.
I just hope its the clutch shoes.
Ok. my throttle linkage bellcrank over rotated and the truck was WOT upside down for about 30 seconds before I could shut it off. Now the truck wont move on the ground. If i lift it, the wheels go...
it is .5 ... For McMaster, use Item # 91294A130
Better off going with Big Bores.. The Powerstrokes have been discontinued.
My LHS ordered 2 sets of the seal kits today for me..
Now I just hope thats all it is.... its a rear one so I dont feel like disecting until its repair time. The rears are a pain in the butt.
Yes... I destroyed my one way and chewed up my starter shaft...... when I bought a new one way, I switched back to the ez start system... Im kinda scared to try the roto again.
Thanks for the suggestions guys..
I tried on ebay already... nothing.
Thats good to know..
But should I rebuild or just got to the BigBores?
I see on Tower that the Pro-Line Powerstrokes are discontinued.
Bad timing.. One of mine is blown in the right rear.
Should I rebuild the powerstrokes or just go with the big bores?
I dont real do...
I got the RD Logics on the 2.5 and the shaftes keep popping out... Today I lost a rear.. repared it and 10 minutes later a front popped out.
I do have a full set of MIP Shiny's on hand.. Imay be...
You may want to change both bulks while your at it.. I had a very similar hard crash like that (them curbs do not move) and found that I had cracked my other bulk. I only spotted this after doing a...
Details are in sig...
What is a modded .18 TM??? ;)
And what is the solution for this?
Im getting my .18 TM tomorrow and I would like to be prepared.
Also, is the manual's break in procedure good, or is...
Ballistic has a great package.. they do have a tray that you can charge the 8 TX batts in with the same charger.
Im looking into this further, I had this idea myself - the search works great.
I work in a machine shop so
we have the materials and machines to do so. If we find a solution, we will make a nice...
WOW I got lucky on that one. :p
I just got done putting my Maxx back together after new bulks, all skids and chassis braces - all from ACNCM.
I didnt think it made a difference - I got lucky...
I let my brother in law take my T-Maxx for a spin today (that was a mistake) -
He slammed into a curb dead on squared at 3/4 throttle - here is the damage:
A couple other free file hosts are:
ok... ill let you know how I make out tomorrow.
thanks for the help.
@ PhunkyPhish: The "good luck" scares me. ;)
I was wondering what the best procedure is for changing chassis. I got the lightweight chassis from Fastlane.
The truck is brand new and never been taken apart so I am not familiar with the...