Search:

Type: Posts; User: trixter

Search: Search took 0.01 seconds.

  1. Thread: Shock question

    by trixter
    Replies
    3
    Views
    288

    look at the shaft very carefully for any burrs,...

    look at the shaft very carefully for any burrs, they will eat up the 'O' rings quickly.
  2. Drive the snot out of it, replace what breaks...

    Drive the snot out of it, replace what breaks with quality parts. The kingheads motor mount is a good choice to replace broken though.
  3. Replies
    541
    Views
    245,641

    Sticky: I have lost my master for Slash 4X4 Blank set up...

    I have lost my master for Slash 4X4 Blank set up sheet, can someone send me in the right direction.

    Thanks
  4. Replies
    8
    Views
    3,221

    I would say that what you have is fine, if and...

    I would say that what you have is fine, if and when you switch to lipo batteries you might consider 2s packs at around 5000 mah. These might not be as fast as the 3s and 4s (nutzoid), but will keep...
  5. Replies
    16
    Views
    6,696

    Which servo did you get?

    Which servo did you get?
  6. Replies
    6
    Views
    673

    Could you be a bit more specific.... Maybe Part...

    Could you be a bit more specific.... Maybe Part #'s

    Thanks
  7. Thread: Swaybar Info

    by trixter
    Replies
    8
    Views
    434

    Does the 2.3mm piano wire fit through the holes...

    Does the 2.3mm piano wire fit through the holes in the stock hardware?
  8. Replies
    24
    Views
    1,509

    Are you referring to the center shaft bearing, or...

    Are you referring to the center shaft bearing, or wheel bearings?
  9. Replies
    24
    Views
    1,509

    Do you have a part # for that bearing?

    Do you have a part # for that bearing?
Results 1 to 9 of 9