Type: Posts; User: Daedlux
@slaughter33 thanks. I will dremel that out. Didnt think of that.
I ended up using the 2.8 trenchers stretched onto the 3.2 revolvers. Not too much of a weight difference from the 2.8...
Does it bend? Instead of break. I haven't seen it in hand. Nails might work if my hex wasn't so far gone
I like going fast. Hehe. But I suppose I should just take it down a bit😓.I dont have any 3s Lipos yet. But I am still open to suggestions because 4s is fun with a lightweight truck.
Im cutting nails to use as pins right now. Hope it works
Im running a mamba monster with the 2200kv motor on 4s 10000mah lipo. After every bash I end up with only fwd or rwd because im snapping pins inside the hex. 17mm traxxas adapters with trenchers...
I broke an mip x-duty cvd. I was jumping a ramp and a piece of the wood caught a trencher. Wheel went flying away.
Thank you. Did not see it
Has any one put xo-1 slicks on a stampede/Slash for street runs?
Im looking to pick up a set off the bay but wanted to get some opinions on the matter. I finally seen them up close. Size difference...
My trenchers baloon huge on 4s lipo.
A whole lot more than the talons. They are Different rubber compounds.
I thought this was worth sharing. I broke the slipper input shaft and shedded a motor mount bearing. Almost landed It.
Stretched 2.8 trenchers on 3.2 RPM revolvers.
17mm hex. I was actually able to go through my lipos running 4s.
I was thinking of getting xo-1 wheels w/ 17mm hex. Im not sure what tires I would be able to run them with. I have stripped 5 wheels out now with a similar setup. I have aluminum hex's and tighten...
First pic could not be viewed
I used my proline stampede body.
I cut new holes in the very back of the bed.
I did the slash chassis conversion and it makes it handle so much better. I have mip axles all the way around. The fronts rub the aluminum steering blocks. Not too bad. It will grind it down to...
I have stripped 4 wheels out in two days on 4s lipo. This motor is beast. Im still waiting on my 3.2 revolvers with the 17mm hex. Hopefully those will be strong enough.
What wheels are...
Im running with the slash chassis converted from the stampede. After a bunch of speed runs and messing around on 4s temps were awesome. Barely over 105 on both esc and motor geared 18/54. I did not...
Im excited to see how its going too. I just put the 2200kv in my xl pede but cant run it till I get some c-hubs. Will post pics and a running video real soon.
The pin and the drive cup broke.
Good idea with the nail.
Yeah a bit. I was trying to prevent it from nosediving. I guess I will give the summit shafts a shot.
I just got this erevo yesterday. Upgraded to cvds all the way around including the center shaft. Doing speed runs was all good but a couple of good jumps is all it took.
I like launching it and bashing around on my backyard track. I dont really have space to get up to speed but really also just want a cool running reliable motor/esc combo to bash with. I didnt say...
@ Rc Fan. Have you clocked this setup on a gps or radar?
Thanks for the info. Thats about what Im looking to get out of it. With brutal torque through most of the run.
So what kind of speed could I expect from the 2400kv extreme sct setup?
Geared 21/54 with 4s lipo.