Type: Posts; User: nitroal
just finished my son's carnage body to go racing with tomorrow!! these things are a pain to do right!!! i hope it looks great racing for all the trouble it was to get together.
you don't really need any suspension changes for the wheels, but you might want to make some changes for the new rubber.
one of these:
my wife starts to complain about what i spend occasionally, then i just ask her what she spends playing in her dart league. she gets quiet pretty fast!!
wide ratio will be faster than the close ratio. i am running the standard ratio with a 17cb and 38 spur. i am waiting for the wide ratio right now, but i am not sure i can control that much speed on...
i run the traxxas 3232 plugs and 33% fuel. i love the combo!!
i had that problem on my 18. check your idle first. then work on your low speed adj. i have found that the 18 will idle at a little higher rpm than most of the other engines i have had.
i have an os 18tm in my truck with a tecno rc wing. i am still looking for the right tires. i run the p2 rockers and am very happy with them. i am also running the standard ratio tranny gears set up...
hey slippery! there are no other hobby shops near us. i get most of my parts on ebay or other on-line stores. the other tracks in the area are in evansdale and urbandale. i think you are going to...
i use the hot racing bi-directional clutch and just love it. it was a little tight at first, but after a couple of tanks it has broken in and really hooks up good.
i am using the traxxas 3232 plug and 33% fuel. i love the combo.
you can get the tiger drive fairly cheap on e-bay and if you have a cordless drill, the battery will last much longer than the other starters.
will 17mm put any less stress on the axle pins?
i would love to get a full set of RD , but right now i don't have the $200
i have them shimmed to the point where when tightened down the pin just sits inside the notch. i have been racing for a while now and this is the first combo i have run where i have had this problem.
i am running an os 18tm with 23mm 40 series bo ties. i keep breaking my axle pins. does anyone know where i can get some stronger pins. i really like my combo and don't want to go to smaller tires.
where did you get your set-up jig?
what transmitter are you using? if it has end point adjustments, check them. i wouldn't try moving the carb unless everything else fails.
you can get them here: http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXEMZ0&P=X
sometimes you can get them cheaper on ebay.
my os is eb modded. i run around 240 normally. if i need a little...
i use the traxxas 3232 in my 18 and just love it.
that is pretty sweet revoracer3.3!! if i did a lot of bashing i would put this in in a heart beat. but being a racer, the extra battery is just to much weight. great job!!!:D
could be your bearings going bad, stub shaft getting worn, or maybe a bad wheel
it is the little blue protectors. you can use the plastic wrench with the little spikes on it to adjust them
no, it is 5:14 central time. less than an hour to go though!!!
the laws are different in every community. best thing to do, would be call your local law enforcement and ask.