Search:

Type: Posts; User: VGP12

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    41
    Views
    1,449

    Whatever charger you have, make sure it has the...

    Whatever charger you have, make sure it has the ability to balance as well. THis will get you the best performance and longest life out of your lipos. SPC are great, and so is Traxxas' offerings. You...
  2. Replies
    5
    Views
    512

    Thanks for the replies everyone. Come to think of...

    Thanks for the replies everyone. Come to think of it, I did switch from the stock Traxxas 8 battery 2.4ghz to the newer 4 battery TQ out of my VXL recently, and I really noticed the problem a drive...
  3. Replies
    5
    Views
    512

    Whats going on with my steering?

    Just got the old ERBE back up and running again, and now it won't turn consistently, primarily when trying to turn left. It will sometimes go, sometimes it won't, sometimes it will jump around, its...
  4. Replies
    7
    Views
    226

    Get a castle link system for like 30 bucks and...

    Get a castle link system for like 30 bucks and turn your torque down to like 50%. I did this to mine and it still wheelies like a madman but I haven't broken a single drive shaft for a while. *knock...
  5. Replies
    30
    Views
    5,897

    My gears never used to come off. Now that I've...

    My gears never used to come off. Now that I've rebuilt my Rustler and finally got it driving again after like a year, they keep falling off... Hopefully the blue locktite I got will work.
  6. Replies
    9
    Views
    1,399

    They make brushless conversion kits for micro...

    They make brushless conversion kits for micro helicopters with similar sized motors to the Alias. They come with an extra control unit for the motor. If the alias was capable of carrying 4 of these...
  7. Replies
    2
    Views
    491

    I would say no. The alias bearings are not...

    I would say no. The alias bearings are not sealed, and putting lube on them will make whatever grime or dust the quad encounters to stick to the grease, in turn fouling the bearings. The best...
  8. Thread: Oops!!! Help!!!

    by VGP12
    Replies
    8
    Views
    263

    yeah a 7500 kv is way to high of a KV for the...

    yeah a 7500 kv is way to high of a KV for the stampede 4x4. That ESC will work fine, but get the Traxxas Velineon motor. Geared right it works great, I use one geared way down on my E Revo in the...
  9. Thread: Prep work for 6s

    by VGP12
    Replies
    5
    Views
    400

    Just dial down the punch control on your ESC,...

    Just dial down the punch control on your ESC, tape your tires, be careful, and you should be fine.
  10. Thread: Motor problems

    by VGP12
    Replies
    15
    Views
    1,733

    959 motors have been working well for me. They...

    959 motors have been working well for me. They don't have as much power as the stock motors, but I bet that's what makes them last longer. I have been beating on them and they still have worked fine...
  11. Time for the v959 motors :)

    Time for the v959 motors :)
  12. Replies
    14
    Views
    785

    You can purchase the Castle Link system. This...

    You can purchase the Castle Link system. This lets you plug in the speed controller via USB and adjust how the truck performs. You could turn the max throttle, torque, and reverse down to like ~20%....
  13. Replies
    28
    Views
    2,016

    Its pretty simple. You need a soldering iron, not...

    Its pretty simple. You need a soldering iron, not a gun, that operates right around ~30 watts. These are small gauge wires and too much heat will be bad.
    I would start by practicing on some thin...
  14. Replies
    28
    Views
    2,016

    Compared to micro quads, obviously the Alias is a...

    Compared to micro quads, obviously the Alias is a lot more difficult to fly indoors because it is larger. Take it into a gym though and it will really shine. I found it also needed some adjustment...
  15. Replies
    16
    Views
    1,691

    Don't fly it in a small room because it caries a...

    Don't fly it in a small room because it caries a lot more momentum than the other 2 micro quads I have...

    Do swap to v959 motors. I've had mine in for about ~10 runs and so far they've been...
  16. Replies
    10
    Views
    486

    yep i keep my punch control at around 50-60...

    yep i keep my punch control at around 50-60 percent. Still wheelies like a bat out of heck when I punch it but I haven't broken a single drive shaft since changing those settings. Braking also at 50%...
  17. Replies
    15
    Views
    323

    Just gear low and break it in properly and that...

    Just gear low and break it in properly and that should be a great motor. Traxxas gears some of their vehicles way too high out of the box.
  18. Replies
    43
    Views
    1,490

    If you break something, replace it with an RPM...

    If you break something, replace it with an RPM part. Thicker and not brittle. The only aluminum anything I would recommend is the front caster blocks, because if you put a flexible RPM part there,...
  19. Replies
    4
    Views
    130

    Pretty sure they got deleted. I haven't been on...

    Pretty sure they got deleted. I haven't been on the forum for a couple years and coming back I couldn't find some stuff.
  20. That is a nice bird! I just use paperclips....

    That is a nice bird!

    I just use paperclips. Cheaper than the body clips and you can twist them whatever way you want!
  21. Awesome. I also paid around 15 bucks for mine....

    Awesome. I also paid around 15 bucks for mine. They are on their way from China but when they come I'll post the results.
  22. I got WLToys v959 motors. There was someone else...

    I got WLToys v959 motors. There was someone else on the forum who did the same thing but the thread was taken down due to flaming. They are the same size as traxxas motors and people have been having...
  23. Replies
    21
    Views
    1,007

    I don't know about the e revo MIPs, but I had...

    I don't know about the e revo MIPs, but I had them on my rustler and busted them the day after I got them. Hit a wall on 3s by accident and all my RPM stuff bent and nothing else broke but the shaft...
  24. Replies
    14
    Views
    752

    I love 4s on mine. I bought matching 3s packs to...

    I love 4s on mine. I bought matching 3s packs to run 5s and 6s, but they just sit on the shelf in storage mode becausue whenever I use them, I break something lol
  25. Thankfully my motors haven't failed yet, but just...

    Thankfully my motors haven't failed yet, but just in case I ordered some cheap off brand motors that were the same size, simply because the only place I can find the Traxxas motors is on eBay for...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4