Search:

Type: Posts; User: randy0050

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    861

    thank you Craig !! just what i needed

    thank you Craig !! just what i needed
  2. Replies
    700
    Views
    239,787

    they work great on pavement

    they work great on pavement
  3. Replies
    5
    Views
    861

    e-revo motor change 1717 ?

    i received a 1717 xo-1 motor in a parts swap.. i understand it uses a bigger esc. anyone heard of someone putting it on a e-revo ? i have 2 erbe,s and got put it on one of those ... input anyone ?...
  4. Replies
    31
    Views
    7,861

    the question is if we alter the gear set up to a...

    the question is if we alter the gear set up to a much taller gear could we gain mph and bottom end torque . the muck taller gear in a single gear setup would put to much strain on the drive train...
  5. Replies
    31
    Views
    7,861

    what is we use the taller gear set up would it...

    what is we use the taller gear set up would it then be feasible ?
  6. Replies
    4
    Views
    1,080

    there is the magnet holder that goes on the spur...

    there is the magnet holder that goes on the spur gear. or if you can find a small round magnet , you can glue it to spur gear .
  7. Replies
    4
    Views
    1,080

    you dont have the cover on it already ? mine came...

    you dont have the cover on it already ? mine came with the spur cover with the port on it
  8. Replies
    10
    Views
    797

    what vxl said also

    what vxl said also
  9. Replies
    21
    Views
    2,054

    use loc-tite on heli-coil installation so they...

    use loc-tite on heli-coil installation so they dont back out
  10. Replies
    21
    Views
    2,054

    teflon tape until you get heli coils

    teflon tape until you get heli coils
  11. Replies
    10
    Views
    797

    set your multifunction to thottle and see if you...

    set your multifunction to thottle and see if you adjust from there
  12. Replies
    9
    Views
    869

    could a broken clutch spring a the sound is the...

    could a broken clutch spring a the sound is the spring against the clutch bell. does it try to take off when you start it ?
  13. Replies
    6
    Views
    587

    might have been a small piece of trash in the...

    might have been a small piece of trash in the carb and you got it out when ya re-adjusted it
  14. Thread: New engine

    by randy0050
    Replies
    8
    Views
    595

    dont think its the bearing but ok. Take your time...

    dont think its the bearing but ok. Take your time and look over everything , from bad fuel, to glow plug, etc. you just took apart the whole engine and sometimes you over look the small things
  15. how is tempertures ? air leak ? exhaust manifold...

    how is tempertures ? air leak ? exhaust manifold gasket ? more imformation would be helpful
  16. Replies
    28
    Views
    1,988

    outerwears A++++++

    outerwears A++++++
  17. Replies
    9
    Views
    916

    stock gearing is fine for what you want

    stock gearing is fine for what you want
  18. Replies
    7
    Views
    1,082

    I like the panty hose idea! you could prob. spray...

    I like the panty hose idea! you could prob. spray KNN airfilter activator on them to keep some more moisture out
  19. Replies
    20
    Views
    1,351

    i have those big 40 series trenchers on my ERBE...

    i have those big 40 series trenchers on my ERBE brewers !! they fun as **** on big jumps, but you have to be very, VERY carefull !!
  20. Replies
    21
    Views
    1,585

    i would not run the stock batteries unless you...

    i would not run the stock batteries unless you make sure the low-voltage setting is correct
  21. look into outerwears is you are worried about...

    look into outerwears is you are worried about water !!! they work . i go through water and mud, the when i take the outerwear off , there is still dust on my electronics, motor, and everything under...
  22. good notes all .. i need to check out those diff....

    good notes all .. i need to check out those diff. housings !!
  23. i did a few backflips off a willow tree. I kinda...

    i did a few backflips off a willow tree. I kinda got confident a mashed on it at the trunk of the tree and it ended up 20 ft in the tree. i have a video of it going about 12 ft. one time i launched...
  24. thanks 87 !

    thanks 87 !
  25. Replies
    8
    Views
    1,083

    super glue a small round magnet on the flywheel....

    super glue a small round magnet on the flywheel. they will have a small divet in the circle pattern. as long as you have the wire sensor from the reciever connected.. works like a charm
Results 1 to 25 of 107
Page 1 of 5 1 2 3 4