Type: Posts; User: brahall
I have a Revo2.5 (with OS18 and MANY MANY upgrades over $1200 invested) I have a stock Jato 3.3 and well over $500 worth of new and used Revo spare parts. any ideas or any offers
Just wanted to bump it
I went by the book on setting the FS. When the radio is turned off the servo goes to the position set during FS programing but when turning off the car or disconnecting the RX pack the servo only...
But when the battery dies what allows the throtle servo to re-center. If the throtle servo doesn't re-center it will stay in the position it was in when the RX pack dies and the throtle return spring...
:mad: I have a DX3.0 Radio and the reciever that comes with it. I know it has a Fail safe if the radio batteries die, but what if the RX batteries die.
That happened today and I had a run-away....
Agree, This mod is great, and you can use a spring from a disposable ink pen. Just cut it to the right length.
Check the mesh between the CB gear and the Spur gear. If it is too tight there could be to much resistants there.
Pro-Line Road Hawg Steet tires and TRX dish wheels
:confused: What spur/CB gear should I use to keep the gearing the same when going from a factory 2.8 wheel to a 2.2?
The filter neck will hit the Spur gear. I did the MS mod and fabricated the stock filter neck to work on the MS filter. It is a simple mod
Do some searching and you will find it.
I had to grind a slot in them with a dremel and use a Flat head screw driver being careful not to cut into the backplate.
Once I got the screws out I replaced them with...
What would I need to convert my Revo E-Z Start to a Roto Start.
The car currently has an :unsure:S.18TM on it.
Try leaning out the HSN. That should work.
Would you use the RR 2's on the front and rear?
What are the best high speed wheels and tires for the JATO.
I keep blowing the beed on my factory A:eek: nacanda tires.
If the car is new the engine is usually so tight you have to get it pretty hot for it to be able to move the piston. Maybe try re-heating with heat gun or hair dryer.
Does anyone know of another quality steering that I can use for a single servo steering on a revo. No one seems to have this one in...
Mod complete and it worked like a charm.
I forced the peice of fuel line over the spring and also used a short section of a ink pen tube...
Thanks for the help fellow Jato'ers
:confused: I am new to the JATO scene, I am used to the MT's that have brakes that will launch you into a front flip if adjusted to tight. My Jato however at speed takes as much as 100 ft to stop. Is...
I just wanted to post that going with the Hitec 5955TG (333oz .15sec @ 6v)
Is the way to go. I did this upgrade yesterday and it is FAST and STRONG.
Highly Recommended...:) :rolleyes:
I have a Tekno wing mount on my Revo and would love to have one for my Jato. Any links on rear wing mounts for a Jato.
I just destroyed my front right axle carrier. What should I upgrade to? Or just keep Her stock on the Axle carriers??
:confused: Will plasti-dipping the RX and servo's cause them to overheat and burn out quicker??
Also when PD the RX dow do I keep the PD out of the connectors?