Search:

Type: Posts; User: Seegee911

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    137

    Bearings, then shocks if you're on a budget. If...

    Bearings, then shocks if you're on a budget. If not, do both. The stock red plastic shocks can get kinda gummed up with dirt, so you may have to clean them regularly to keep them moving smoothly. But...
  2. Yeah, I posted earlier regarding the limits of...

    Yeah, I posted earlier regarding the limits of this chassis. Sure you can stuff power into it, but your video shows nothing but spins in the kitchen. Try doing a Speed run, or actually driving a...
  3. Replies
    11
    Views
    2,055

    The one way aluminum drive shaft basically...

    The one way aluminum drive shaft basically applies power to all four wheels when on the throttle, but when braking, it allows the front wheels to continue to spin freely while stopping only the rear....
  4. Replies
    10
    Views
    246

    No worries! Mistakes happen. Lol. But yes,...

    No worries! Mistakes happen. Lol. But yes, stiffening the bellcrank does help. I'm using the aluminum steering assembly from GPM, and it's spring seems stiffer than stock. Worth looking at for your...
  5. Replies
    10
    Views
    246

    The Teton runs a completely different wheel,...

    The Teton runs a completely different wheel, different shock towers, and has a much wider stance than the Rally. It also does not use a servo saver.
  6. Replies
    10
    Views
    246

    My experience with this chassis showed me that...

    My experience with this chassis showed me that there is a limit to the speed that it can handle. When I was running the stock chassis, with the 5300Kv motor, control was very unpredictable. The...
  7. Replies
    86
    Views
    26,951

    Yeah, the only real difference with the Teton...

    Yeah, the only real difference with the Teton Diff vs the rally diff is that the Teton Diff has metal gears. The bulkhead is identical, so it should just pop right in.
  8. Replies
    11
    Views
    2,055

    Thanks! It drives like a completely different car...

    Thanks! It drives like a completely different car now. Lol.
  9. Replies
    11
    Views
    2,055

    I've taken some updated Photos of my Rally. Added...

    I've taken some updated Photos of my Rally. Added the last of the metal components. Thus may be one of the most Hopped-up rally's around.

    https://goo.gl/photos/TpFiDchk1JRuavna6
    ...
  10. Replies
    0
    Views
    50

    Updated Photos

    I've taken some updated Photos of my Rally. Added the last of the metal components. Thus may be one of the most Hopped-up rally's around.

    https://goo.gl/photos/TpFiDchk1JRuavna6...
  11. Replies
    86
    Views
    26,951

    This thread has so much valuable information....

    This thread has so much valuable information. Here's a bump to keep it from fading away!
  12. Check your steering to see if it moves freely...

    Check your steering to see if it moves freely left and right while disconnected from the servo.
  13. Ok. If you're losing motor speed, it's likely...

    Ok. If you're losing motor speed, it's likely that the servo is sucking power. What battery are you using? To check the servo horn, remove it from the servo, turn on the car, Center the wheels by...
  14. Replies
    11
    Views
    580

    On that note, Traxxas does have an Aluminum...

    On that note, Traxxas does have an Aluminum Spool. (#7581)
  15. It's hard to say without a little more...

    It's hard to say without a little more description of the problem.

    Does the motor actually slow down when turning, or does it just turn sharper in one direction than the other?

    How's your...
  16. Replies
    11
    Views
    2,055

    I listed the part numbers in my op. Basically,...

    I listed the part numbers in my op. Basically, I'm using the metal input gear from the Teton Diff Kit that slips on to the end of the driveshaft. Because I'm using the ball diff in the front, and the...
  17. Replies
    10
    Views
    246

    I ran a 17 on the stock motor, and temps got too...

    I ran a 17 on the stock motor, and temps got too high, and it killed the battery (7.2v NiMH) in about 6 minutes. Then I swapped out the motor/esc with a 5300kv mamba micro combo, and kept the stock...
  18. Replies
    11
    Views
    2,055

    Thanks for the comments! Just picked up the last...

    Thanks for the comments! Just picked up the last of the Aluminum parts this morning. Will get those swapped out this week. There isn't much that's stock anymore... At this point, it's the wheels,...
  19. Replies
    2
    Views
    184

    What did you change regarding the diff?

    What did you change regarding the diff?
  20. Replies
    11
    Views
    2,055

    SeeGee911 Hopped-up Rally

    There's a huge list of modifications to this little thing. It's been a side project of mine, and has turned out quite nicely, so I thought I'd share!

    Upgrades :

    Chassis
    Traxxas Carbon Fiber...
  21. Replies
    5
    Views
    189

    Umm. Pretty much everything. The only stock parts...

    Umm. Pretty much everything. The only stock parts on it have their replacement on the way already... I'll start a new thread about it.
  22. Thread: latrax375

    by Seegee911
    Replies
    3
    Views
    151

    I use automotive bearing grease. Also marine...

    I use automotive bearing grease. Also marine grade. Got a lifetime supply of it at home depot for $8. I use it on all my RC
  23. Replies
    5
    Views
    308

    What's the spline on the servo?

    What's the spline on the servo?
  24. Replies
    3
    Views
    468

    I have a small condo with hardwood floors, and I...

    I have a small condo with hardwood floors, and I can rip it around pretty well. But it is more fun in a parkade or tennis court. The only thing that I am having issues with is the tires. Need more...
  25. Replies
    10
    Views
    403

    Ask them for a photo of the back of the rim. Can...

    Ask them for a photo of the back of the rim. Can they take measurements for you? Don't ask if it fits, ask the measurements.
Results 1 to 25 of 78
Page 1 of 4 1 2 3 4