Search:

Type: Posts; User: Double G

Page 1 of 20 1 2 3 4

Search: Search took 0.21 seconds.

  1. Replies
    1
    Views
    23

    Pinch of the engine is tight or you have the...

    Pinch of the engine is tight or you have the screws holding the starter are too tight. If the first: put a little WD-40 down the glow plug hole to loosen it. If the latter then loosen the screws;...
  2. Thread: lst diff

    by Double G
    Replies
    10
    Views
    106

    BOOM !

    BOOM !


    <Oomp drops the mike and walks away>



    :lol:
  3. Replies
    3
    Views
    41

    Of course the lights will turn on, it shows there...

    Of course the lights will turn on, it shows there is power going to the circuit, it is up to the receiver of that power to move. Make sure you are getting full battery voltage from the red and black...
  4. Small screw on top, loosen it and then twist the...

    Small screw on top, loosen it and then twist the arm.
  5. Thread: lst diff

    by Double G
    Replies
    10
    Views
    106

    IF anyone in the nitro world did the LST diff it...

    IF anyone in the nitro world did the LST diff it would be few and far between. Take a look at the electric side and see what the gearing difference is and then adjust accordingly.
  6. Replies
    58
    Views
    4,891

    I guess if you want a back-up to a dead starter...

    I guess if you want a back-up to a dead starter box, but typically people don't run both.
  7. Replies
    9
    Views
    184

    When this happens look at the light coming from...

    When this happens look at the light coming from the receiver and the light(s) on the ESC and report back your findings. Could be a radio issue where you'll need to dig deeper or if it is a Castle...
  8. Replies
    17
    Views
    233

    It is my understanding that all Traxxas 2.4...

    It is my understanding that all Traxxas 2.4 radios have a failsafe installed where the throttle returns to neutral. And we all know that if it loses signal the truck will continue on its course...
  9. Replies
    17
    Views
    233

    The engine won't die but the throttle will return...

    The engine won't die but the throttle will return to neutral. A 10 pound truck is quite a weapon when driving around people. Nitro or electric both can lose connection with bad results.
  10. Thread: Airborne

    by Double G
    Replies
    2
    Views
    72

    Throttle control or make a wheelie bar.

    Throttle control or make a wheelie bar.
  11. Replies
    17
    Views
    233

    :O.o: I would be surprised if his nitro has an...

    :O.o: I would be surprised if his nitro has an ESC.


    First off, make sure your batteries are charged. Is it a new truck? Purchased used or you've had it for a while?
  12. Replies
    4
    Views
    80

    It's a 4908 T-Maxx (based upon what the body and...

    It's a 4908 T-Maxx (based upon what the body and battery box say, as well as the layout of the chassis) but has the blue pipe that looks like it was jerry-rigged. Ditch it and get the correct...
  13. Replies
    5
    Views
    126

    https://traxxas.com/forums/showthread.php?9042788-...

    https://traxxas.com/forums/showthread.php?9042788-Summit-or-Emaxx
  14. The stock 17mm adapters will fit other 17mm hex...

    The stock 17mm adapters will fit other 17mm hex rims but the Traxxas 17mm rims will not fit other 17mm adapters without modification.
  15. You may have gotten the wrong plug and the piston...

    You may have gotten the wrong plug and the piston could have been hitting it. You need a standard plug for the 3.3 not a Turbo plug. Make sure the wand battery is fully charged and don't continue to...
  16. Replies
    3
    Views
    84

    Batteries charged? Many people have reported...

    Batteries charged? Many people have reported problems with the Opti-Drive sensor and remove the module. There is no problem with taking it out and plugging the throttle servo directly into the...
  17. That's part of the tranny case....

    That's part of the tranny case.
    https://traxxas.com/explodedviews/Ford-Raptor-58064-1-Transmission-Assembly
  18. Replies
    5
    Views
    138

    Which charger? If I'm looking correctly you...

    Which charger? If I'm looking correctly you should be able to charge the new and old style lipo.

    https://traxxas.com/sites/default/files/2972_EZ-Peak_dual_legacy-LiPo-Start-w-NiMH-iD.jpg
  19. Replies
    4
    Views
    122

    I went the extra cheap route. I use a spare Maxx...

    I went the extra cheap route. I use a spare Maxx tire/rim on my LCG Slash; tipped a 2x4 on its side and screwed a 1x3 to the bottom and use that for my Revo. Nothing pretty but they work.
  20. I can get a couple hours worth of use out of my...

    I can get a couple hours worth of use out of my 1600 mah pack. I end up charging it before it completely dies so the actual run time is unknown. It would suck to have a battery die during or right...
  21. Replies
    2
    Views
    101

    So you have a 2.5 engine and the description...

    So you have a 2.5 engine and the description says:


    If you don't want a pull start, don't want the EZ Start there are no other options besides this (all others have been discontinued). You will...
  22. Engines need four components to run: air, fuel,...

    Engines need four components to run: air, fuel, glow and compression. Take one away and you have a paperweight. Yes they can suddenly go out.




    I've been here long enough to know that with...
  23. Replies
    2
    Views
    75

    Cutout faces the carb as well as the oiler holes...

    Cutout faces the carb as well as the oiler holes on the rod.

    Also make sure the cutouts on the back plate face up.
  24. Change the glow plug. It may light up when...

    Change the glow plug. It may light up when there's power applied but would not be able to stay glowing on its own.
  25. Thread: Chassis

    by Double G
    Replies
    4
    Views
    85

    The chassis under the engine has been known for...

    The chassis under the engine has been known for being a little weak and bending and this could be your case. Once it bends it becomes weaker. A new chassis can be had for cheap and should be the end...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4