Type: Posts; User: Jurgen
Post some pics if you cant figure it out so we can see what you are working with .
I like the OS .21 TM and Picco .26 both are great engines .
We had a good size jump at work after plowing the lot .
Looks like fun . Snow is fun we build snow jumps alot of people are missing out as they save their rc's for summer use only .
You can check by removing the piston and sleeve and push the piston if it goes through the sleeve and comes out the top its worn out .
why not trade your motor at ur local hobby store it will be cheaper and yes they will work with pull start or ez start .
I have one in my revo and its a awesome engine .
looks nice but hpi stickers on the body and wing ?
they are not both pink the 2020 (fronts) are purple the 2040 (rears) are pink . http://www.jacoracing.net/newitems_foam_rubber.html
reset the needles to the factory specs and tune from there . 1 3/4 turns on the lsn and 4 turns on the hsn .
If the truck has been seating for 2 years i would offer him $100 for the tmaxx with the old 2.5 if it runs and drives maybe 150 . If it doest run you can trade it in for a new 2.5R and pay only $85...
They do but this game was for points not to get disqualified .
good luck and listen to this guys caz they know what they are talking about .
Finally you got one . Is it a 3.3 ?
let me know how they work whatever route you go maybe later i'll switch my revo cups and the 77 to a 78mm dog bone even tho its been serving me well so far .
part numbers are HPI86151 (77mm ) HPI86057 (78mm) and TRA 5153R I am using the revo cups with the 77mm dog bone on my tmaxx with the picco and no problems at all . I'll try a 78mm one if something...
order them online either the 77 or 78 mm and the cups plenty of places have them . the links and part numbers are above .
My radios are the same way i am assuming its for programming the radio or something .
yes it will and you will like it .
Thats just for the rear the front one is fine stock . Usually people break the rear center and thats what i run on the 4908 tmaxx with the picco maxx .
on the 4908/4907 you can use a Hpi 77 mm dogbone and revo cups . part numbers are HPI86151 and TRA 5153R and you should be good .
1 70mm UE Titanium dogbone
1 57.5mm UE Titanium dogbone
2 5mm UE hardend steel cups
2 6mm UE hardend steel cups
this is whats needed for a tmaxx for the smaxx you need the 70mm and one 5mm and...
If he uses a revo pipe it might look clean i dont know about the bend of the tmaxx 3.3 pipe and looking clean . http://i165.photobucket.com/albums/u75/telcntar/100_2059-1.jpg