Search:

Type: Posts; User: Redfire427

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    602

    Upgrade to 10 gauge wires to the ESC and change...

    Upgrade to 10 gauge wires to the ESC and change all your connectors to EC5 and your problem will go away.

    Carmen
  2. Replies
    71
    Views
    23,869

    Sticky: Here is some quad-copter / Spartan video action....

    Here is some quad-copter / Spartan video action.

    Carmen


    https://vimeo.com/102091174
  3. Replies
    10
    Views
    1,018

    Heat the strut up with a propane torch and the...

    Heat the strut up with a propane torch and the bearings will fall right out.

    Carmen
  4. Replies
    12
    Views
    1,445

    I'm guessing you will need a new motor. The same...

    I'm guessing you will need a new motor. The same thing happened to me, and the magnets sucked all the debris into the core of the motor and took out the armature.

    Carmen
  5. Replies
    4
    Views
    667

    The general rule of thumb is to grease the flex...

    The general rule of thumb is to grease the flex cable after each run. I actually grease mine after every third run. I have run two complete summers with the original driveline using the Traxxas...
  6. Good suggestion hog. I do have a few battle...

    Good suggestion hog. I do have a few battle wounds that could be causing the issue.

    Carmen
  7. I've been meaning to ask this question myself. I...

    I've been meaning to ask this question myself. I get about half a litre of water inside the hull after each 3-1/2 minute run. I can't for the life of me figure out how it is getting in. I have the...
  8. Replies
    5
    Views
    1,071

    6 beeps ? What's that all about? Mine does 3....

    6 beeps ? What's that all about? Mine does 3.
    Sorry to hear about your ESC.
  9. Replies
    8
    Views
    671

    I'm not sure what you are looking at, but the...

    I'm not sure what you are looking at, but the entire rudder assembly is $27 from Kintec. This price is a steal and the quality is outstanding.
  10. Replies
    8
    Views
    671

    The Kintec rudder makes a huge difference in...

    The Kintec rudder makes a huge difference in handling, and the cooling is superb. There is definitely more drag and lower speed as a result. I think I will machine-off about a half inch to help...
  11. Replies
    5
    Views
    770

    I get all my batteries from outside the country....

    I get all my batteries from outside the country. Great prices.
  12. Replies
    71
    Views
    23,869

    Sticky: https://vimeo.com/42894948

    https://vimeo.com/42894948
  13. Replies
    14
    Views
    1,257

    It sounds like you are hooked on speed. If so, a...

    It sounds like you are hooked on speed. If so, a 3S set-up will be the way to go. With 5000mah lipo batteries, you will only get about 4 to 5 minutes of hard running. They will also get very hot and...
  14. Replies
    27
    Views
    2,592

    You are lucky that thing didn't explode on you....

    You are lucky that thing didn't explode on you. Read up on lipo batteries and you will see how much danger you had in your hand. Get rid of those batteries immediately. Listening to the audio in your...
  15. Replies
    9
    Views
    1,272

    Wow, that is expensive for batteries and a...

    Wow, that is expensive for batteries and a charger. I ordered mine through Hobby King and I paid $36 each for the 3 cell 4000mah lipos, and $14 each for my two chargers. Everything works like a...
  16. Replies
    8
    Views
    646

    My buddy had the same issue with his Spartan and...

    My buddy had the same issue with his Spartan and was hitting the thermal cut-out. It turned out that he had the rudder kicked-back too far which obviously affected the flow of water. Once he...
  17. Replies
    9
    Views
    1,272

    CA glue and a little kicker will do the job...

    CA glue and a little kicker will do the job nicely.

    How on earth did you spend $1000 on a Spartan?
  18. Replies
    17
    Views
    1,760

    That motor has sat with water in it for prolonged...

    That motor has sat with water in it for prolonged periods of time. Every time I submerge the motor, I open it up, use compressed air to blow the water out of the windings, then apply a little bit of...
  19. Replies
    9
    Views
    1,240

    Thanks for the replies guys. I guess I will give...

    Thanks for the replies guys. I guess I will give the EC5's a try.
  20. Replies
    9
    Views
    1,240

    Battery connectors

    Hey guys,

    I need someone to point me in the right direction to get some better connectors for my batteries. I am using some Dean's connectors soldered onto the leads and I am running into a...
  21. Replies
    5
    Views
    606

    5711X is the part number ...

    5711X is the part number

    http://buy.traxxas.com/product_info.php?cPath=9485_7615_8205&products_id=8525

    Carmen
  22. Replies
    2
    Views
    499

    Just open up the receiver and hit it with some...

    Just open up the receiver and hit it with some compressed air and it will be good to go. The motor will be full of water also. It is pretty simple to remove the tray, remove the motor, remove the end...
  23. Replies
    2
    Views
    521

    You can get any replacement part from Traxxas....

    You can get any replacement part from Traxxas. Just click the category for a complete list of part numbers and...
  24. Replies
    11
    Views
    861

    $220 is half the price of new. Go for it.

    $220 is half the price of new. Go for it.
  25. Replies
    13
    Views
    2,100

    Quite simple really. The hatch is the weakest...

    Quite simple really. The hatch is the weakest part of the boat, not to mention, it is also the highest point which can affect the lateral stability of the boat. In the event of a high speed spill,...
Results 1 to 25 of 32
Page 1 of 2 1 2