Type: Posts; User: riverrattt
Not often. I'm in Houston Texas right now.
Every now and then I get over toward the tenn-tom
I moved barges around. Put 1000 gallons of fuel on the boat, took on 800 gallons of drinking water , pumped a bunch of dirty bilge water off the boat.
Oops I guess I should mention I work on a boat...
i have a long list of things ive hit . the two worzt ones i can think of are/
a road sign post in the state park i run in . i hit it a 40 mph and the truck just disintegrated.
the other real...
To the original poster=
A two wheel drive revo will be squirrelly to handle . No doubt about it. However it can be made into a decent dragster by using some lead weights to distribute the weight...
looks like it may be a servo arm screw to hold the arm to the servo .
just a guess
need to tune it. as said lhs people love to sell engines.
may make sure your wheels are aligned( even if it drives straight) . same thing happens on a 1:1 car when the wheels arent aligned correctly.
it doesnt have to be much out of alignment (...
definately RPM a arms. ( id also suggest the rpm true trak a arms on the rear.
heavier shock oil.
i wouldnt get to enthusiastic on...
i made the mistake of counting up how much it costs once. i wont do that agian.
i keep the receipts now i just dont add them up. i figure when i retire ill figure up the amount spent on rc for...
iive seen them also. i gotta say they are nice lookin trucks.
when my parents drove show trucks for circle c , it usually took 12 to 18 months to get a matching truck and trailer sprayed. ...
when i was a kids my parents drove for a company called circle c,
they drove show trucks. it pulled regular loads during the off season . but during show season in the summer i rode with them...
its behind the spur gear on the tranny
They pop out of regular drive cups at high speed with the true trak a arms
I think the true traks are just a rad wider then stock.
The extended drive cups are for the adjustable wheel base a...
With true tracks on the back you will need the traxxas extended drive cups if you use traxxas cvd's
Either the one way bearing is slipping on the shaft because it is dirty. Try cleaning it with denatured alcohol .
Or the one way bearing is put on backwards. The text on the bearing should go...
Some reason it posted twice
Favorite truck Toyota 4x4 . I managed to get that one
Favorite car . New dodge challenger bought with art package then adapted to my liking. I'm determined to get one soon
Dream car , 65...
Oops my bad . Sorry.
Guess I've gotten to used to seein 3.3 and 2.5 and over looked the .15
Did you return your needles to factory settings?
If not then they may still be setup at whatever setting you were running before rebuild. This is probably to
Lean for a break in and needs to be...
Rpm a arms
Titanium toe links.
Wing with either a traxxas or tekno wing mount
If running rich the black plastic part of the seal will leak.
Ive had a few 3.3's that leaked between the inner bearing race and the crankshaft, but that is kinda rare.
Once they start...
It could be running hot . It could also be after run oil burning off if some was spilled when the procedure was done .
Also check the seal on your tank lid . They sometimes wear out
Are your fuel lines hooked up correctly?
The line runs from the pipe to the top of the tank then the other goes from the bottom of the tank to the fuel inlet.
I'd also check for a kink or crimp...
Sounds like some grease from the easy start or pull start. if it is I wouldnt worry about it
As for the wining noise my revo does it to. I figured out that my brakes were dragging and cause the...