Type: Posts; User: TheGuy
The motor I am running is the Venom 8.5t which is 5200kv. I want to be able to drive on the street and offroad as well.
Also I have 2 different lipo packs, one 2s 30c 5000mah and one 3s 30c 5000mah
What would be a good gearing on a 5200kv setup? Was curious what kv the VXL motor is.
I would buy it all right now for 350
A 3000mah sport pack will do just fine. Check out your LHS they prolly have something that will fit the bill for around 20-25$
^ Looks nice, but a nice piece of lightweight alumn. is pricey, plus the proper tools to cut and drill it.
Across the spectrum everyone had problems with these motors holding a good tune. There were the few who swore up and down by them but now a days you hardly see them, O.S. has been the top dog in...
Replace the stock a arms with RPM ones when he breaks the stock ones. Not much else I can think of you would need right away other than some extra glow plugs. Depending on the model you buy you might...
Revo.. I have owned them all and the revo is a good truck. Its a sturdy truck. If you wanted to get him into nitro without the big bucks you could also look at the nitro stampede which is lots of fun...
Can you guys compare a chevy 4x4 vs a ford 4x4...
Give me a break. Your going to get a hundred opinions either way. The revo and the savage are not the same kind of machine. But based on your...
Anyone have a discount code for tower thats current?
Servo spoken for. 3.3 back up for grabs after buyer flaked. 3.3 not 50% off :rolleyes:
Yeah I have had an aluminum one in the past and hit a half buried cinder block and it caused all kinds of problems. So looking to replace the one on the truck.
Its Thanksgiving... 50% off everything. Last chance
If its a 23mm wheel yes
I have two FLM sealed diffs.. both holding up well on a 6200kv bl with 3s lipo. The screws included work fine, and no shimming required. Recheck and rebuild the diff and see what you think when you...
I dont see how you guys are breaking the mip cvd's. Must be your driving, because I have used cvd's on most of my rc's for years without any problems and if I did it was due to my driving faults.
Never could understand why you would want to make an all aluminum truck. I would rather that someone like RPM make an all plastic conversion but replacing all parts including the chassis.
Does anyone make a good front skid plate? I just got a 2nd hand revo and it has a blue anodized aluminum. I prefer plastic to aluminum especially for the front skid. Was curious if anyone makes...
Looks good. Wonder if it will be up to par with RPM. Too bad RPM doesnt make a wider variety of parts.
+2 Junk & waste of money. Integy has good intentions but the quality of parts never last.
+1 I found other good uses for (pony tail) rubber bands as well. Lol'd as I read it because I use them all the time. My girls get :mad: when I take them
Dont think you have the right idea. If your on the prowl to buy a used revo just keep searching the "MARKET PLACE" here or on other forums and pm potential sellers. You will get better results that...
A lil wd40 and a toothbrush and all those parts would be clean ;)
Looks good. Cant wait to see it in a video. If you do go brushless get a moderate kv motor and you will have tons of fun.