Search:

Type: Posts; User: Double G

Page 1 of 20 1 2 3 4

Search: Search took 0.10 seconds.

  1. True Track has a set toe in (track) for the rear...

    True Track has a set toe in (track) for the rear that cannot be adjusted. If you go with normal arms all the way around then you can adjust the track.
  2. Replies
    1
    Views
    52

    Bumping it for the day.

    Bumping it for the day.
  3. Replies
    1
    Views
    52

    TRX 3.3 engine w/3.4 carb

    Tried to sell it on eBay, but apparently no one likes to pay up. It's going back up here for the time being.

    Broken in last fall using the Traxxas method then additional 8-10 tanks after that (it...
  4. Replies
    8
    Views
    101

    Water boils off at 212F/100C so you can assume...

    Water boils off at 212F/100C so you can assume the temps were in check if the top of the head caused it to evaporate slowly and then off near the plug.
  5. Replies
    20
    Views
    311

    Marvel Mystery Oil is what I would use, otherwise...

    Marvel Mystery Oil is what I would use, otherwise you could clean it with WD-40 and then Marvel or even after-run.
  6. Replies
    4
    Views
    77

    The GTR shocks are, IMHO, the best for the Revo. ...

    The GTR shocks are, IMHO, the best for the Revo. Given the center of gravity, this truck is not going to turn on rails. I would recommend going to the GTR shocks and also going with a Traxxas or...
  7. Replies
    2
    Views
    94

    Best thing is to contact the manufacturer...

    Best thing is to contact the manufacturer regarding questions about their charger.
  8. Replies
    4
    Views
    107

    Take a look at the T-Maxx side for Popeyepulls...

    Take a look at the T-Maxx side for Popeyepulls (or some variation of that name) and see the rig(s) he's built.
  9. Replies
    2
    Views
    67

    NOT recommended as they are not able to filter...

    NOT recommended as they are not able to filter the small particles that would ruin our engines.
  10. Thread: broken header

    by Double G
    Replies
    7
    Views
    131

    Yes. You'll also need #5254 to hold it...one is...

    Yes. You'll also need #5254 to hold it...one is okay, two springs is better. I conveniently have one for sale in the MP... ;)
  11. Replies
    13
    Views
    191

    Clean the OWB first but also make sure that you...

    Clean the OWB first but also make sure that you don't really wrench down on the screws holding the pull start to the back plate. Snug is just fine.
  12. No. It is for the shocks.

    No. It is for the shocks.
  13. Replies
    2
    Views
    62

    Keep the weak link plastic otherwise your next...

    Keep the weak link plastic otherwise your next damaged part will be further down the drivetrain.
  14. Replies
    2
    Views
    81

    Do you have the exploded views? If not, go to...

    Do you have the exploded views? If not, go to the Support button above and download them.
  15. Thread: Rpm sensor

    by Double G
    Replies
    4
    Views
    56

    The Traxxas flywheel has a magnet on it for the...

    The Traxxas flywheel has a magnet on it for the sensor to pick up the rpms.
  16. Replies
    7
    Views
    117

    When you start does it want to take off while...

    When you start does it want to take off while cranking? Check & replace clutch. Then look for air leaks.
  17. Replies
    6
    Views
    178

    I had a response but when the forum hiccuped it...

    I had a response but when the forum hiccuped it disappeared. You may want to contact Ray A Racing and see if he does international. I've used him in the past and from the day I shipped to when I...
  18. Replies
    7
    Views
    117

    Vague description. What have you done to remedy...

    Vague description. What have you done to remedy it? Stock settings on the carb? Everything air tight?
  19. Replies
    10
    Views
    100

    1. Are you sure you have the Revo/Slayer neck or...

    1. Are you sure you have the Revo/Slayer neck or T-Maxx? What size spur do you have? Have you verified if the chassis is bent under the engine?

    2. It is difficult and the best tool I used was...
  20. Replies
    12
    Views
    208

    It's certainly up to what you want. I was happy...

    It's certainly up to what you want. I was happy with the 3.3 w/3.4 carb and THS pipe and now I have a newly installed O.S. .21TM w/THS pipe waiting to be run.
    Many big blocks are cheaper than that...
  21. Replies
    2
    Views
    68

    If I recall, the older Opti-Drive is not...

    If I recall, the older Opti-Drive is not compatible with the newer radios. You could get a new one or bypass the OD altogether--just be careful not to switch into reverse while driving forward.
  22. The Opti-Drive was a safety for the shift servo...

    The Opti-Drive was a safety for the shift servo not to switch into forward/reverse while the truck was moving so you save your transmission.
    You could easily upgrade to Traxxas new TQi 2.4ghz for a...
  23. Got your PM. Make sure the steering servo is...

    Got your PM. Make sure the steering servo is plugged into channel 1 (there are 2 ports, pick the one closest to channel 2) and the ESC is channel 2.
  24. Channel 1 is for steering, channel 2 is for the...

    Channel 1 is for steering, channel 2 is for the throttle. You didn't plug them back in correctly. There's a nice diagram of it in your manual too.
    Plug it in correctly and it will blink.
  25. Very nice!

    Very nice!
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4