Type: Posts; User: yaleman
I have ordered AER-1902 Aeromarine Stuffing Tube with Teflon - .187X18 also for my boat, and will be getting Jeffs .187 drive cable to match, I've seen that this works on other tube bending methods,...
Trim tabs adjusted so that the outside tips are flush with outside strake of the boat. I just used a ruler to align. I have my batteries as far forward in the compartment as they can go. My boat...
Overall I manage about 10 mins or so run time before I have to head into shore running average 1/2 throttle with wot bursts, quick but fun! I have a leopard 4082 and seaking 180esc to install for...
Thats how I set mine up, wired 2 together in series, soldered the wires, covered with heat shrink, then soldered to ESC. Running boat with dual water cooler/esc p/u, oversize tubing, oversize motor...
Well according to their web site...."We sell the top quality aluminum electrolytic ultra low ESR capacitors from Rubycon .. Rubycon ZLH 35v 1000uF 12.5X20mm"
Same ones sold at kracing for .75
105oC Miniaturized, Long Life, Low impedance
Rated Voltage: 35v
Rated Capacitance: 1000uF
Capacitance Tolerance: 20%
Temperature Range: -40 to 105C
I picked up 10 caps from the cap king .60 each free shipping Rubycon ZLH 35v 1000uF 12.5X20mm
Are the caps wired in series or parallel?
Disconnect the motor leads when binding the receiver and esc.
Ose has Rubycon Low ESR Capacitor 35v Rated Capacitance: 1000uF, would I just add these to my current esc +-, any other changes to be made?
I have a new Traxxas Velineon 3500, brushless, never used, make an offer?
My drive gear got chewed up by the brass motor gear, I have the replacement parts, just wondering should
I be putting any oil or grease on this gear before assembling?
Anyone recommend using this, looking at using this along with Seaking 180a esc, using both intake and dual small/large bore outlets for my esc only, leaving the rudder water intake for motor cooling...