Search:

Type: Posts; User: GLMC

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    2,198

    Don't think of the spacers as an aftermarket...

    Don't think of the spacers as an aftermarket crutch - you are supposed to use them. The Slash 2x4 and 4x4 are supposed to be ground huggers for the short course so they do set low. The deep and high...
  2. Replies
    14
    Views
    6,142

    Maybe it is not such a good idea to spend a lot...

    Maybe it is not such a good idea to spend a lot of money on "super bearings" to battle salt and water because they don't make them. If your bashing in salt and snow you must get the salt and water...
  3. Replies
    24
    Views
    1,368

    Yes it is. Here is what I do... Smooth body motor...

    Yes it is. Here is what I do... Smooth body motor and a snap fit heatsink with fan - clean both surfaces - apply course grit rubbing compound to the I.D. of the sink - snap it on the motor and rock...
  4. Replies
    24
    Views
    5,495

    I still run the motor mount bearing in grease...

    I still run the motor mount bearing in grease using a 3s with good luck. It is the clear ptfe grease to lube fishings reels with and when it spins that fast it turns near liquid, like said above I...
  5. Replies
    12
    Views
    482

    Maybe the motor mount bolt is loose letting up on...

    Maybe the motor mount bolt is loose letting up on the gear mesh erratically. It happened on my Bandit, once a noise then no noise, etc...
  6. Very good pick. My best advise would be to order...

    Very good pick.
    My best advise would be to order a few extra parts that typically break. Here's my suggestions:
    6853 Rear axle stubs.
    6893X Slipper clutch bearing and bushing. (If you have the...
  7. Replies
    8
    Views
    1,480

    Also if you buy the REVO 5345R kit with servo...

    Also if you buy the REVO 5345R kit with servo horns for $6.75 then you get two of those tie rod assemblies. And if you don't have a REVO then just toss the horns.
  8. Replies
    8
    Views
    1,480

    If it's the little tie rod link assembly that...

    If it's the little tie rod link assembly that screws to the servo arm then you will find it in the Slayer or Revo parts book. Your looking for 5341X (steer servo tie rod assembly).
  9. Replies
    8
    Views
    585

    reefpatrol, I'm new to the forum and just lurking...

    reefpatrol, I'm new to the forum and just lurking but I think I can answer what you're looking for. Losi only has one 2.5" blue that will fit the big bore it is part A5160. I use it on my 4x4 rear...
Results 1 to 9 of 9