Type: Posts; User: Maxxturbo
i am trying to replace one of the front drive shafts on my t-maxx 3.3 and following the instructions with the part, i removed the wheel, axle pin and hex hub..however how can i remove...
I got a body for a used truck , The guy told me it is a 3.3, All the body posts and mounts line up perfectly except the exhaust pipe. Can you please look at let me know if i have the wrong exhaust?
All is good it worked.
Thanks once again
ok thanks I will try and let you know how it went.
Can anyone please advice the best or easiest way to unhook the rear shocks, the set that is closes to the engine?
On one side the muffler is blocking one screw and on the otherside it is the gas...
glad to hear it worked then!! one of my plugs is missing a connector from the prvious owner i am trying hard to find this one for now i just wrapped it around the ez start motor does the...
Yes looks like that , one way bearing.
How Do i get my t-maxx to pop wheelies, the front end will not go up. Maybe I could tune it better?
I dont know what I am doing wrong.
Is the filter clean ? So you got the motor to start finally? but it goes very slow is that the problem?
The 240 piece screw kit looks amazing. ! nice screws
Ok thanks a lot,i got this truck used ( big mistake to make ) now i am left someones problem, someone who didnt know what they were doing and put any screw anywhere. So i will order the tony's screws...
Thats a great idea , I will try that. I never thought of that.
Thankyou everyone , this place is so helpful it is unbelieveable.
I will let you know how it goes.
Here are the pictures of the screws I need help removing. If you could please take a look and provide some assistance on how to remove them...
I will post a picture today , thankyou all for your help
If you look at the t-maxx from the bottom where the brace fixes to the chassis , I am looking at one of the screws there
You mean cut a slot where the head is missing or the other side? Basically there is no head. just the shaft
What would you recommend to remove a screw with no head on it:confused:
I would like to know as well.
thanks so much, I will use what I bought and then try out the aluminium one.
I got the hitec 5345 X Lincoln87, is there a special horn ?
thanks for the assistance I am using a hitec5645mg , The link from towerhobbies is a round servo saver I think my t-maxx 4907 uses a different kind like a u-shaped one ,do you know...
I bought a used maxx and found out that my steering servo is broken. What do you guys recomend as an upgrade for a servo saver, when i hooked up a new servo the screw is moving but the wheels are not...