Search:

Type: Posts; User: rlopez

Page 1 of 17 1 2 3 4

Search: Search took 0.11 seconds.

  1. That's cool!! If you have 3rd channel mixing you...

    That's cool!! If you have 3rd channel mixing you can set it up so the break lights come on when you hit the breaks/reverse:cool:
  2. Radio shack lights plus Radio Shack resistors=...

    Radio shack lights plus Radio Shack resistors= cheap bright lights. I built a set of 4 lights for under $7
  3. Have you ran it yet? If not give it a few packs...

    Have you ran it yet? If not give it a few packs and you'll be making a "why did my RX8 stop working?" thread....I went through 3 of them :(
  4. Replies
    16
    Views
    806

    I don't see a buy it now button.

    I don't see a buy it now button.
  5. Replies
    28
    Views
    1,942

    IMO, the slash takes way more skill to drive. I...

    IMO, the slash takes way more skill to drive. I see it like this, not every one has the ability to balance a spinning plate on a stick. Some people get upset and decide to spin the plate on their...
  6. Replies
    7
    Views
    283

    THe VXL ESC is known to go bad and lose the LVC...

    THe VXL ESC is known to go bad and lose the LVC feature. I know all 3 of mine have. Now I run it in NIMH mode with an LED voltage indicator.
  7. Replies
    47
    Views
    8,460

    Yes.......

    Yes.......
  8. Replies
    47
    Views
    8,460

    Dude, mark the shock shaft with a Shapie at the...

    Dude, mark the shock shaft with a Shapie at the base of the shock, at the desired ride height. Then just lift the truck, measure how many mm that is and cut a piece of fuel tubing to that length....
  9. Replies
    28
    Views
    1,697

    Integy= Feces

    Integy= Feces
  10. Replies
    17
    Views
    899

    I have this same balancer and I love it! Been...

    I have this same balancer and I love it! Been using it for over 2 years now. I don't know if the Blinky displays individual cell voltage but this one does. Up to 6S.
  11. Replies
    47
    Views
    8,460

    Just make sure you use new fuel line. Nitro tends...

    Just make sure you use new fuel line. Nitro tends to wear it out then it will split.

    I'm glad people are opening their eyes to what the truck should of came with as far as shocks. These shocks...
  12. Replies
    47
    Views
    8,460

    rjames, get away from the heavy oil mindset with...

    rjames, get away from the heavy oil mindset with these shocks. IMO, heavy oil is necessary when a shocks is being forced to perform outside of its scope, I.E. a heavy truck with small volume shocks....
  13. Watch that end bell because they like to come...

    Watch that end bell because they like to come off. I drilled and tapped some screws in my 6xl. The 6XL likes to run very hot though. 220* hot on 2S unless you gear it no higher than a 15T pinion.
    ...
  14. Replies
    47
    Views
    8,460

    The hard springs are too much for this truck. The...

    The hard springs are too much for this truck. The truck is too light. Keep in mind the Slash weight 4 pounds and the Ten T weighs 6 pounds. The hard springs in the front cause the truck to rebound...
  15. Replies
    23
    Views
    1,229

    Dale, IMO its is overkill in the sense that its a...

    Dale, IMO its is overkill in the sense that its a very heavy system. I had a 2200 system in my first slash, on 4S with the throttle dialed down to 90%, and had to upgrade to Losi 8 shocks to make it...
  16. Replies
    23
    Views
    1,229

    Where did you see that system more expensive than...

    Where did you see that system more expensive than the MMM? The Novak is listed for $239 at tower and the MMM is listed for $299. That system runs cool unless you gear it too high. Stay between 12-14T...
  17. Replies
    47
    Views
    8,460

    Right on! Let us know how it goes.

    Right on! Let us know how it goes.
  18. Replies
    47
    Views
    8,460

    You can find every part number for the shocks and...

    You can find every part number for the shocks and springs here. Yes, they have medium and soft springs....
  19. Replies
    47
    Views
    8,460

    The shocks aren't the same length. The shafts...

    The shocks aren't the same length. The shafts just all come in a pack together and its hard to tell from pictures. Both the rear bodies and shafts are longer.
  20. Replies
    47
    Views
    8,460

    Rjames, they fit every shock location on the...

    Rjames, they fit every shock location on the tower and on the arms. They also are an exact fit as far as length. Losi shocks are super easy to build because the piston is held on by a nut, not a "c"...
  21. Replies
    3
    Views
    270

    Yes you should run foam in them.

    Yes you should run foam in them.
  22. Replies
    47
    Views
    8,460

    Tested mine last night an was impressed as well....

    Tested mine last night an was impressed as well. Settled on 35wt in the rear with medium springs and 25wt in the front with medium springs. Night and day handling with no leaks.
  23. Replies
    50
    Views
    2,238

    I run a VXL esc with a Hacker 13.5 sensored motor...

    I run a VXL esc with a Hacker 13.5 sensored motor on *********(*****) 2S and it runs awesome.
  24. Replies
    7
    Views
    1,390

    The VXL esc is great for spec racing with...

    The VXL esc is great for spec racing with sensored motors. I run a 13.5, I don't spec race, and it works great for me!
  25. I raced a Slash with the Pro's at West Coast...

    I raced a Slash with the Pro's at West Coast Raceway here in SoCal and placed 2nd and 3rd more than once in the A Main, against mostly OFNA sponsored drivers, and I've only been "racing" for about a...
Results 1 to 25 of 405
Page 1 of 17 1 2 3 4