Search:

Type: Posts; User: Atomicpunk

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    14
    Views
    1,615

    The muffler (tuned pipe) is important because it...

    The muffler (tuned pipe) is important because it pressurizes your fuel tank and it is designed to provide back pressure pulses to the engine to keep the air/fuel ratio correct. Without it, your...
  2. Replies
    10
    Views
    2,920

    Check your slipper clutch (you adjust it with the...

    Check your slipper clutch (you adjust it with the nut that holds the spur gear on the transmission). Make sure it's not slipping too much.
  3. Replies
    3
    Views
    280

    Check your engine mount.

    Check your engine mount.
  4. Replies
    4
    Views
    395

    Great idea! It looks like it will protect much...

    Great idea! It looks like it will protect much better.
  5. Replies
    6
    Views
    1,297

    I would go with a 17 or 18 tooth CB and a 1/8th...

    I would go with a 17 or 18 tooth CB and a 1/8th scale clutch with a 36 tooth spur gear. Even with this gearing, you will have wheelies, but it will be more controllable. The wing is a must have. I...
  6. Replies
    15
    Views
    3,476

    I have had both the S23RE and S27RE engines. ...

    I have had both the S23RE and S27RE engines. With the exception of displacement, they are both identical. I was able to use the stock linkage with the roll hoop removed. It is difficult to get the...
  7. Replies
    1
    Views
    336

    I had those wheels for a little while, they...

    I had those wheels for a little while, they looked cool, but were to heavy. I had a problem with rubbing too. I set my steering end points in a little. You can try these hub adapters (they are...
  8. Replies
    9
    Views
    450

    Looks nice and clean. What engine are you...

    Looks nice and clean. What engine are you putting in?
  9. You should demand your money back today. Don't...

    You should demand your money back today. Don't leave any feedback until the money is back in your hands, then leave negative. If he doesn't refund you today, open a dispute case through Ebay and...
  10. Thread: 2 Questions

    by Atomicpunk
    Replies
    11
    Views
    415

    I did a 1970 Ford F-100 body a couple of months...

    I did a 1970 Ford F-100 body a couple of months ago. Here's what it looked like before I beat it up.

    http://i148.photobucket.com/albums/s10/tamneric/001.jpg
  11. Replies
    14
    Views
    344

    Typically, off road engines will have a larger...

    Typically, off road engines will have a larger cooling head that is more appropriate for the added work and stress on the engine due to off road driving.

    Just drop one of these in your Revo...
    ...
  12. Replies
    4
    Views
    425

    I have also had great luck with Odonnell glow...

    I have also had great luck with Odonnell glow plugs, but I use the red one (med-hot)
  13. Thread: 2 Questions

    by Atomicpunk
    Replies
    11
    Views
    415

    You need these gears..........

    You need these gears....... http://www.amainhobbies.com/product_info.php/products_id/3395/n/Traxxas-Revo-Gear-set-2-speed-wide-ratio-2nd-speed-gear-38T-13T-18T-input-gears-hardware
  14. If you are not racing, it is less expensive, less...

    If you are not racing, it is less expensive, less maintenance and adjustment, won't break as easy, no need for rear brake, less front tire ballooning, and the most important reason.......wheelies!!! ...
  15. I agree. If you do not plan on racing, I would...

    I agree. If you do not plan on racing, I would just install a FOC and 17/36 gears.
  16. It looks great. If you want to clean it up even...

    It looks great. If you want to clean it up even more, you could go with a single steering servo. also, you can buy just the tranny case halves if you wanted to go back to a more stock look. Over...
  17. Replies
    20
    Views
    578

    I would not waste your money on those for a...

    I would not waste your money on those for a basher. The stock drive shafts are tough as nails. I do recommend sway bars.
  18. Replies
    12
    Views
    1,278

    That's right, they are the Bluegroove sways. I...

    That's right, they are the Bluegroove sways. I don't use them anymore, the Traxxas sways are a better design. Also, you have to remove your bumpers to use the Bluegroove sways.
  19. Replies
    12
    Views
    1,278

    That body looks great. I had a red Baja Beetle...

    That body looks great. I had a red Baja Beetle body a couple of years ago and loved it. I will definitely do another Baja body when my Ford f100 body is finally wasted. When I paint a body, I cut...
  20. I'm on my 5th gallon on the Picco, and it's...

    I'm on my 5th gallon on the Picco, and it's running stronger than ever. The compression is still great, and I still feel a little pinch in the sleve when the engine is cold and the glow plug is...
  21. Replies
    10
    Views
    714

    I used to run the Sirio S23RE (which is the same...

    I used to run the Sirio S23RE (which is the same exact engine as the RB) I didn't care for it to much. I had an issue with it leaning out on left turns. I don't use that air filter neck...
  22. Replies
    20
    Views
    505

    Sounds like your clutch is engaging too soon due...

    Sounds like your clutch is engaging too soon due to worn or broken spring. check your idle gap on the carb to make sure that it is 1mm and set your low speed needle to flush with the housing. also...
  23. Thread: Any ideas?

    by Atomicpunk
    Replies
    4
    Views
    211

    That's probably exactly what is going on. it...

    That's probably exactly what is going on. it only happens when I brake hard, the front end dives down and it goes click click click click click :lol:
  24. Replies
    7
    Views
    741

    You are going to have a hard time getting those...

    You are going to have a hard time getting those gears to fit. You will probably need to dremmel your engine mount. 16/36 or 17/36 is your best bet for the Picco. You don't necessarily need a side...
  25. Thread: Any ideas?

    by Atomicpunk
    Replies
    4
    Views
    211

    Thanks. They are both due for a rebuild, so I'll...

    Thanks. They are both due for a rebuild, so I'll tear them apart.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4