Type: Posts; User: josh12845
Easiest way is to remove the front end by removing the 4 or 6 screws(cant remember which) on the bottom of the chassis. The front then slides out making it easier to center your steering.
not that i have seen. due to the fact the front wheels have 2 barings and a spacer.
has it been broken in? has it been tuned? acceleration could be from lsn needing leaned out. tighten the screw on the spur gear in a little. looks way out compared to mine. might have too much slip....
May sound dumb, but if your cover the pipe hole while trying to crank, it will pull the fuel to the carb, also now as "priming". Sometime when first starting, mine wont pull on its own, I have to...
Fronts- Definetly go ribbed. I run dirt and the anacondas sucked, and all the terrain tires didnt do great. Ribbed was awesome. For the rear- idk maybe a paddle to run in the sand pits.
if it seems like its turning the engine over and then stops, but the motor on the easy start keeps spinning, then its the one way bearing in the easy start. about a $20 fix.
Thanks for the quick reply. I've never noticed that set screw and i've had it apart probably 20 times. But your absolutely right. That fixed it. Thanks again.
Long story short. old carb cracked. Bought a new one. But the horn for the throttle servo is upside down from the old one and it binds my servo a little. Can this be adjusted on the carb? For...
Look really close around the bottom of the carb and engine. if you see a little bit of nitro, then its prob the carb o ring or a hairline crack in the carb. Obviously remove to inspect. Hope this...
Thanks. Ill look again this weekend. It didnt look twisted to me, but maybe i need to remove all the parts to check it out.
my new body is the same exact way, so i know the body is beat up but thats not it
The chassis appears to be level. I removed the towers and put them back on. Still nothing.
I have a Jato 3.3. The stock body doesnt fit on the body mount studs. If you place it on the front body mount pegs, the rear holes in the body are about 1/4 inch past the mounting studs. Bought a new...