Type: Posts; User: troyhebert
I had to dremel my p4de when I installed a 4065 2700kv.
Im running 3s with 2700kv geared 19/54. Slipper is the HR double slipper with the 6 short alu pads adjusted perfect. I bash hard and speed run it.
So this week i go pick up my new XO-1 diffs and new drivers from mip. Excited for the new diffs. Surprised i havent blown the stock diffs yet.
Big bores or gtr shocks. Integy is weak materials. Their motor fans are good. Other shock options are HPI D8s front shocks or OFNA LX2e front shocks. Lots of posts on these two shocks.
I would start with 3767 alu shock caps and 6983x bearing adapter. After that, replace parts as they break. Running 2s, stock axles should be good. Running on pavement, you will want to get a set of...
Thats a good find for $8. I cant find one for less than $30 on amazon. But like Marioffroad said, you need the hardened pinions which run about $12 or so if I remember correctly.
Post a pic or two of the slipper do we can see the setup.
My first thought is check that the pin is in the right hole on the slipper shaft if you cant tighten the nut all the way down. There should be two holes in the slipper shaft.
Im running the leopard 4056 2700kv with the same esc on 3s and love it. Tons of power and cool temps. Geared 19/54 with trenchers.
Still hard to have any input when you still havent given us any info on gearing and batteries.
Old windowscreen would work really good too. I might have to try this.
I threw a hw 120a and leopard 4065 2700kv in my p4de. The chassis does need a little bit of dremeling for the motor but geared 19/54 on 3s snd it flies.
Once you remove the whole rear end, you will see the slipper similar to the pic below. Mine is an upgraged heavy duty double slipper. Circled is the nut to tighten. Tighten it fully then back off 1/4...
+1 on the maui jims. Ive got two pairs of rimless styles and love them.
Nope. Had to dremel the chassis a bit.
Im running a leopard 4065 2700kv motor in my p4de on 3s and man loads of power.
Ok so i did this and the leds only flickered a couple of times. The esc did once beep at me while doing this. I dont currently have an external bec installed. Thats why i thought i needed to install...
What will that tell me jimdog?
Yea its a spc 6500 3s lipo
Didnt notice. Now I just had it out and blew both inner and outer bearings in one for the rear carriers.
Well finally had some nice weather and time to run the p4de with all the upgrades ive done to it. Now looks like i need to install a bec. When i pull the trigger, the led light bar blacks right out...
They seem to work pretty good so far. Havent been out much since i installed it. Spring is finally here to stay.... i hope.
You can either order a set of long pads or two sets of short pads. Both will work. With the short pads, you will use all 6. I ordered two tra5352x. With the p4de, the internal diameter of the revo...
Well after a long cold winter, (hopefully over now), p4de is all put to back together with all the new parts I've been ordering over the winter. STRC motor mount, STRC C hubs, STRC steering blocks,...
Spur sounds like a bad mesh or the motor is kinda loose and stripping the spur. Check the screws the secure the motor in place and check the grub screw on the pinion. For the rear end, check the...