Search:

Type: Posts; User: snapshot4

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    12
    Views
    3,580

    Yes I also use a pull start to limit what I carry...

    Yes I also use a pull start to limit what I carry in my pockets when bashing. So with the pull start I carry an ignitor, small screw driver and temp guage. Which is very easy to manage.
  2. Replies
    97
    Views
    5,528

    Makes sense....I did some speed runs today and...

    Makes sense....I did some speed runs today and used the RPMs to calculate speed and it worked out. So the world is back to being round again, it drives me nuts when the math doesn't work out :$#!!:....
  3. Replies
    97
    Views
    5,528

    Nice run powers telemetry is good enough for me...

    Nice run powers telemetry is good enough for me that thing was moving.
  4. Replies
    97
    Views
    5,528

    I did do some testing and changing the gearing in...

    I did do some testing and changing the gearing in the app garage affect the RPMs not the speed. My guess is that the speed is based of the shaft RPM (the actual count) and the motor rpm in the...
  5. Replies
    97
    Views
    5,528

    Ducati777 I get it now so because the RPMs are...

    Ducati777 I get it now so because the RPMs are measured on the shaft vs the motor the spur and pinion gearing makes no difference. So the only ratio to use in the calculation would be the diff ratio....
  6. Replies
    97
    Views
    5,528

    I think the documentation on the telemetry and...

    I think the documentation on the telemetry and the speed calculation is a broad overview at best. Is there a Traxxas employee that can weigh in on this? The question is if you don't change your...
  7. Replies
    97
    Views
    5,528

    The gear ratio for the stock gearing is 9.36...

    The gear ratio for the stock gearing is 9.36 meaning the shaft will turn 9.36 times per 1 turn of the axial. But put in the high speed pinion and then the ratio changes to 3.85 so now one turn on the...
  8. Replies
    97
    Views
    5,528

    Tires you can also change in the garage. The...

    Tires you can also change in the garage. The tires have the radius/diameter built in so the can do the proper calculation. If you tire isn't listed you will have to choose something close to the size...
  9. Replies
    97
    Views
    5,528

    No the rpm is not figured by the center shaft the...

    No the rpm is not figured by the center shaft the sensor is just built into the motor mount. The magnet however is in the spur gear so as the gear rotates the calculation is done there. If you change...
  10. Replies
    4
    Views
    495

    Funny I have a jato 3.3 also and I have to make...

    Funny I have a jato 3.3 also and I have to make sure I run that first because if I run it after my XO1 then it just seems slow.
  11. Replies
    97
    Views
    5,528

    No it does have an affect here it is right out of...

    No it does have an affect here it is right out of the help of the Traxxas app in the garage:

    Traxxas Link relies on specific information about your model to generate accurate telemetry data. If...
  12. Replies
    19
    Views
    2,230

    Good tip with the glow plug. Thanks for the info...

    Good tip with the glow plug. Thanks for the info new piston and sleeve are on order.
  13. Replies
    97
    Views
    5,528

    I dont understand all the people giving negative...

    I dont understand all the people giving negative reviews on the telemetry. I have seen posts of people stating that GPS is the only way to accuratly measure your speed. In fact GPS is not nearly as...
  14. Replies
    19
    Views
    2,230

    This is my second engine I ran about 4 gallons...

    This is my second engine I ran about 4 gallons through my first one until the cooling head popped off from the engine block separating. My LHS hadn't seen that before. I run my engines hard and I am...
  15. Replies
    19
    Views
    2,230

    Double G, that's my point I priced it out and I...

    Double G, that's my point I priced it out and I am $40 shy of a new engine. But do I go with another TRX 3.3? I like the engine but the piston and sleeve are so expensive. So not sure if I will just...
  16. Replies
    19
    Views
    2,230

    So now the question is do I buy new piston and...

    So now the question is do I buy new piston and sleeve or new engine?
  17. Replies
    19
    Views
    2,230

    Upon further inspection looks like the connecting...

    Upon further inspection looks like the connecting rod snapped and then pushed a hole into cylinder head.
  18. Replies
    19
    Views
    2,230

    TRX 3.3 Piston Problem

    So yesterday I was running my car when all of a sudden it just died on me and the engine was seized to the point that I couldn't move it at all. So I took off the cooling head and saw that a hole was...
  19. Replies
    6
    Views
    1,327

    I use the tqi remote for my jato with iPhone. It...

    I use the tqi remote for my jato with iPhone. It makes it much easier to make adjustments, however I find with nitro I don't make very many controller adjustments mostly engine adjustment. Let me...
  20. Replies
    23
    Views
    1,517

    I will take a look into it, but was out with my...

    I will take a look into it, but was out with my jato last night and the engine seized. So gotta get a new cylinder and sleeve first. I hate when this happens.
  21. Replies
    23
    Views
    1,517

    Funny I was just fighting this the other day. My...

    Funny I was just fighting this the other day. My engine was running great for about an hour then it started having idle problems. Could have been dirty filter but I seem to have this a lot with the...
  22. Thread: 2075 Servo

    by snapshot4
    Replies
    3
    Views
    1,050

    Yeah the breaking the servo mount tabs was...

    Yeah the breaking the servo mount tabs was driving me crazy I went through 2 throttle servos. So I made a cover when my last servo broke the mounts.

    http://img.tapatalk.com/a6937b10-7f77-40bf.jpg
  23. Replies
    14
    Views
    1,140

    Mind Read, Looked it up it looks very similar to...

    Mind Read,
    Looked it up it looks very similar to a roto, thanks I had never heard of a torquestart, good to know.

    Desert JATO,
    I agree with you and yes we can all get along :) But, if someone is...
  24. Replies
    14
    Views
    1,140

    I never heard of a torquestart what is that? I...

    I never heard of a torquestart what is that? I know of a rotostart in which you put in a drill and it spins the engine for you, is that the same as a touquestart?
  25. Replies
    14
    Views
    1,140

    Who said pros use pull start? You are the only...

    Who said pros use pull start? You are the only one that seems to think someone is arguing with you on that. Roto and starter boxes are used by pros who race, however I don't race and don't ever plan...
Results 1 to 25 of 86
Page 1 of 4 1 2 3 4