Type: Posts; User: EMaxx_Quebec
Your slipper wasn't tight anought
Tight it a lot ( you'll need a new one lol )
I tow my children with stock one ( blue boots) and they broke but it's my fuse part!
Something have to break somewere!
Emaxx 1717 6s
LST 2 DIFF MOD FOR EMAXX
Your rig is not obsolet AT ALL. Nice to see you back!
Do the LST2 diff mod man!
Here you go!!!
check here cause it's hard to say! There a lot do do, depend on your budget and where you willing ti bring it!
I run a 1717 and Keep All stock brushless mass shaft!
They break but i need a fuse somewere
I didn't toutch my maxx for a long time gathered part,I score this for Under 200$ can recently!
Tested and same here Snap in half!
HERE you,ll find ejector pin
ALL you can try is there
I run mine up to 80% punch control! Ans as i said, use some right size ejector pin!
Bug? What is your mmm setup ? I dont break my driveshaft ofen! Ans i use stock plastic one! Tey eventualy break but are really cheap and easy to replace!
As for my rcm center diff and plate,...
I almost sure! Have to check
And as PowerToThemax said, use EJECTOR pins cut to size as pin replacement
Rock-rod , those diff are no longer unuse! lol
IF you want something in that part bin, let me know, I may sell some few goodies
I still follow your built!!
I might have something for ya!
I have a RCM center diff and the plate to mount it!
Time to go Lst2 diff
Differential Ratio: 3.3076923076923075
Transmission Ratio: 1.7222222222222223
Other Ratio: 1
Spur Tooth Count: 51
Pinion Tooth Count: 25
Total Voltage: 22.20
Motor KV: 1580
For 6S purpose, what are your punch setting on your MMM?
I run mine at 80%
2 years of close eyes for dood deals!
Absolutly! still pulling my kids with it! lol
Back at it guys!
HVL here I come!
I have my LST2 diff since the day one ant they run flawlessly with my 1717 maxx!!!!
New baby, new house, to much to keep being active on forum but I'm back!