Type: Posts; User: troyhebert
Im using the HR double slipper with 6 alu short pads on my p4de with a 2700kv 19/54 running 3s. Have no issues with that setup.
Im looking at $1066 plus 13% tax, so $1200 with current exchange rate. [emoji24]
Yea thx ksb for possibly ruining my dreams lol [emoji12]
I hope the canadian dollar improves before I buy this. Luckily I already have 2 SPC 6500 3s batts for my p4de. Will need to buy a better charger though.
Could be a few things. Mesh is set incorrectly, too tight or too loose. Pinion not tight enough on motor shaft. Bearing adaptor worn out. Bent motor plate. Bigger motor installed and chassis not...
I had to dremel my p4de when I installed a 4065 2700kv.
Im running 3s with 2700kv geared 19/54. Slipper is the HR double slipper with the 6 short alu pads adjusted perfect. I bash hard and speed run it.
So this week i go pick up my new XO-1 diffs and new drivers from mip. Excited for the new diffs. Surprised i havent blown the stock diffs yet.
Big bores or gtr shocks. Integy is weak materials. Their motor fans are good. Other shock options are HPI D8s front shocks or OFNA LX2e front shocks. Lots of posts on these two shocks.
I would start with 3767 alu shock caps and 6983x bearing adapter. After that, replace parts as they break. Running 2s, stock axles should be good. Running on pavement, you will want to get a set of...
Thats a good find for $8. I cant find one for less than $30 on amazon. But like Marioffroad said, you need the hardened pinions which run about $12 or so if I remember correctly.
Post a pic or two of the slipper do we can see the setup.
My first thought is check that the pin is in the right hole on the slipper shaft if you cant tighten the nut all the way down. There should be two holes in the slipper shaft.
Im running the leopard 4056 2700kv with the same esc on 3s and love it. Tons of power and cool temps. Geared 19/54 with trenchers.
Still hard to have any input when you still havent given us any info on gearing and batteries.
Old windowscreen would work really good too. I might have to try this.
I threw a hw 120a and leopard 4065 2700kv in my p4de. The chassis does need a little bit of dremeling for the motor but geared 19/54 on 3s snd it flies.
Once you remove the whole rear end, you will see the slipper similar to the pic below. Mine is an upgraged heavy duty double slipper. Circled is the nut to tighten. Tighten it fully then back off 1/4...
+1 on the maui jims. Ive got two pairs of rimless styles and love them.
Nope. Had to dremel the chassis a bit.
Im running a leopard 4065 2700kv motor in my p4de on 3s and man loads of power.
Ok so i did this and the leds only flickered a couple of times. The esc did once beep at me while doing this. I dont currently have an external bec installed. Thats why i thought i needed to install...
What will that tell me jimdog?
Yea its a spc 6500 3s lipo
Didnt notice. Now I just had it out and blew both inner and outer bearings in one for the rear carriers.