Search:

Type: Posts; User: Selluminis

Page 1 of 19 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    6
    Views
    181

    Which are you running? The high voltage one or...

    Which are you running? The high voltage one or the one that I am running?
  2. All of the post holes failed. The coroners on...

    All of the post holes failed. The coroners on the roof, and by the tail lights shredded. I even used the ole shoe goo and mudding tape for the whole underneath of the body.
  3. I must say. I had the top kick body and shredded...

    I must say. I had the top kick body and shredded it. I changed to the proline apocalypse body with the stock summit roll cage. Had to do some custom stuff with the body posts to get it to work,...
  4. Replies
    6
    Views
    181

    traxxas servos are junk. I am running 2 of...

    traxxas servos are junk. I am running 2 of these.

    http://www.savoxusa.com/Savox_SW0231MG_STD_Waterproof_Digital_Servo_p/savsw0231mg.htm

    Make sure you get a glitch buster. I installed an...
  5. Replies
    2
    Views
    69

    MXL-6 is water proof. Mamba Monster 2 is the...

    MXL-6 is water proof. Mamba Monster 2 is the same on castle's website. I even connect the MXL up with castle link and it is recognized as the MM2.
  6. Replies
    48
    Views
    2,184

    Take my money!!!

    Take my money!!!
  7. Replies
    46
    Views
    3,207

    It is like they combined the engineering of the...

    It is like they combined the engineering of the 4pede with the E-Maxx BL and had a Shaq sized baby. I don't know what I will do if I do not get this truck!!!
  8. Replies
    17
    Views
    409

    Awesome guys! Was thinking about it and I did...

    Awesome guys! Was thinking about it and I did not zero out the trim on the transmitter when I installed the horns. I will do that. Make all the adjustments. Will also check out the toe on the...
  9. Replies
    17
    Views
    409

    Ok, servo saver is deff the issue. Thanks. I...

    Ok, servo saver is deff the issue. Thanks. I still have one question, it still does not turn as far right as left. The wheels do not turn nearly as far. Is this inherent with emaxx or is there...
  10. Replies
    17
    Views
    409

    Still have some trouble shooting to do, but here...

    Still have some trouble shooting to do, but here is the video.

    https://www.youtube.com/watch?v=WcEYqRkwFN4
  11. Replies
    17
    Views
    409

    I will have to look into this. I actually...

    I will have to look into this.



    I actually had all that apart before this post. I though my issue was rounded out horns, so I replaced them with aluminium ones. Had the whole skid plate apart...
  12. Replies
    17
    Views
    409

    Ok, I think you are on to something here. How do...

    Ok, I think you are on to something here. How do I check or fix that?
  13. Replies
    17
    Views
    409

    Not sure what that means. I have a video, but...

    Not sure what that means. I have a video, but will have to wait until tonight to upload because of my crappy internet. When, I put it on the ground, the servos are turning just fine, but the wheels...
  14. Replies
    17
    Views
    409

    Can't steer. What am I missing.

    So, I cannot steer to the right while my emaxx is on the ground. I have Savox sw 0231 x2. Even using BEC to power them. Had done a run with the stock servo horns and those got chewed up, as...
  15. Replies
    11
    Views
    466

    Fist things I upgraded where the center drive...

    Fist things I upgraded where the center drive shafts and the front and rear axel drive shafts. I am using the Traxas sets for both and have not had any issues. A little lighter on the pocket book...
  16. That is what I am running in my Emaxx, but only...

    That is what I am running in my Emaxx, but only the SMC version.
  17. Replies
    190
    Views
    123,897

    Sticky: [QUOTE=ausprime;5937061]https://lh5.googleusercont...

    [QUOTE=ausprime;5937061]https://lh5.googleusercontent.com/-Ut8xI72c9ko/VUh1qzQlW2I/AAAAAAAACr0/5L4a2PJgSx8/w1153-h865-no/IMG_0319.JPG


    very nice. i want to see one of these machines fully...
  18. use spc or smc batts. you want as high of a "c"...

    use spc or smc batts. you want as high of a "c" rating as you can get, at least 50c. do not get anything under 5000 mah for the maxx. try to get hard case batts as well.

    25c batts will work...
  19. Replies
    11
    Views
    466

    you dont need suggestions. you will know what...

    you dont need suggestions. you will know what upgrades to do when you break stuff. lol.
  20. Replies
    8
    Views
    271

    absolutely shim the diffs. these guys gave a lot...

    absolutely shim the diffs. these guys gave a lot of really good advice on all things maxx. check out my thread.

    ...
  21. Replies
    4
    Views
    166

    This track is awesome. Been throwing the idea...

    This track is awesome. Been throwing the idea around myself. I just have not pulled the trigger. I cannot wait to see this thing finished. It already looks awesome. You have put a lot of time...
  22. Thread: Best rc

    by Selluminis
    Replies
    10
    Views
    266

    Luckiest rc basher ever!!!!!!

    Luckiest rc basher ever!!!!!!
  23. Thread: Best rc

    by Selluminis
    Replies
    10
    Views
    266

    Stampede vxl 4x4 is a nice a truck. You will...

    Stampede vxl 4x4 is a nice a truck. You will spend 300 to 350 on it and another 100 to 200 on it to get it where it needs to be imo. Unless, you are lucky and find one already with steel cvds for...
  24. Thread: Mod My FLM

    by Selluminis
    Replies
    23
    Views
    989

    https://lh6.googleusercontent.com/-SgMhFWBhcPw/VUh...

    https://lh6.googleusercontent.com/-SgMhFWBhcPw/VUh2Cni_WGI/AAAAAAAACsk/yq7XRexAmHo/w1095-h821-no/IMG_0330.JPG[/QUOTE]

    So jealous. These builds are insane!!!!!
  25. Replies
    20
    Views
    399

    wait, when do we get pics?

    wait, when do we get pics?
Results 1 to 25 of 458
Page 1 of 19 1 2 3 4