Type: Posts; User: Cyrre
Part 2 of my 1/6 Summit is now available on Youtube
Funny thing is that my phone takes better pictures/movies than my 2yo Casio digital camera :/
three thumbs up, moar 1/6 Summits ;)
Why is ********* censored and maxamp not?
My fault, he damaged the tiny hex screw that locks the pins in place and used shrink tube just to keep the pin in place.
If the shaft breaks in the plastic area were the pin goes through you still might have a chance. Depending on the size of the breakage it can be saved by rotating the shaft 90 degrees and drill two...
With the Rx8 and 2250kv speed is around 50kph+ with stock gearing and 2s lipos.
Runtime with 5000mah lipos is between 30 min and 90 min depending on your trigger finger. Nothing broken so far with...
Do you mean the plastic splines on the center shafts?
Have not seen any tendencies of it yet but its pretty close, its a weak link with less splines lengthwise grabbing each other. My truck is pretty heavy so it will probably show sooner rather than...
Nope, it utilizes the stock axles although they are stretched to the point were the blue dust boots breaks. So shrink tubing is almost needed to cover the exposed splines imoho.
Rollbar in place, made out of 8mm alurod.
Some bling up front, wanted to ad more realism:...
You sir have ALOT of patience....kudos
KD wheel widener kit and move batteries up front?
I'm no expert but isn't the voltage the culprit in how much you shovel into the esc.
Maximum C is only limited by how much the esc draws, so imoh you could have 4 million C without any changes in...
Got a film from todays first test drive, it was freezing cold and i had the phone and remote in the same hand whilst trying to drive it around. Better clip coming up.
I've got one, but it's reversed..
A bystander asked me how much it cost, Summit and all plus upgrades..
When they found out, I was the 1D 10 T ;)
Thanks noir552 and quadiak,
Believe it or not but theres actually not much room for a quad damper setup in the back though its a great idea. And putting an extra spring in front or behind will...
What's the difference between Summits original and P2 rockers?
Edit: Nvm, found this from :http://www.rcuniverse.com/forum/m_7095398/anchors_7097274/mpage_1/key_/anchor/tm.htm#
The thought has crossed my mind once or twice, possibly in a later stage. My biggest concern right now is that the weakness in those purple springs iv'e upgraded to. They are not beefy enough for...
Car is almost done, small stuff to tinker with here and there.
Batteries beneath bed....
The perfect winter setup, chains and a homemade overtray made out of a 5 litre plastic can.
I think Tmaxxcrazy stretched his. Im going to do something similar and fabricate something from spares. Shouldnt be so difficult. Got some ideas ill try tomorrow.
Slight modification of the original chassis:
Then cutting up the spare chassie, what would life be without a dremmel :D...
Throwing in some pictures of my latest project:
Original chassis extended aprox 70mm to fit a Jesse James Silverado SS body with...