Type: Posts; User: mef_cz
I tried solution with zipties.
If it will work and setup will not be worse, throw winter I will try make better solution, that will be acurate to set up....
Hmm, but this still leave stress on rod ends. I dont want use metal rod ends, becouse is better to change plastic rod end then change other parts.... thank you for picture.
Could you post some pictures, how you ziptied front rockers?
I tried it glue and it did not help.
Two of problems was on steel pushrods nad two was on aluminium pushrods.
on our last race, we had problems with four rodends (2 traxxas nad 2 rpm) whiw were pulled out from pushrods.
Allwas it was after bad landing, when car landed on chassis and wheels went...
I am sorry, I was busy at work.
refilled dampers and revised long of pushrods solved my problem.
But erbe was nervous and still turned, but not to only one side.
So I changed front spring for...
I tryed simple think. On the ground I lifter rear of erbe in the center and LR wheel stayed on the ground little bit longer. So I put RR pushrod to the inner hole on arm......and erbe become turning...
May be. I will try. I have diff to change. But "on table" it looks like good.
And what about different lenght of rear ampers or pushrods and different droop on rear arms?
Bearing are good.
Without throttle it stay straight. It turns only on hard brakes.
I have problem with my erbe.
I niticed problem on last race. When I brake very hard, my erbe wants turn to the left. Always to the left.
I tested it on asphalt too. It is tha same. When...