Search:

Type: Posts; User: Bupala1313

Search: Search took 0.01 seconds.

  1. Replies
    15
    Views
    801

    Thanks Stephan81. That was the thread I was...

    Thanks Stephan81. That was the thread I was referring to about the internals and firmware. I wasn't sure it was actually confirmed or not that the ET-3s would allow 6s after the firmware change...
  2. Replies
    15
    Views
    801

    I will change the front shocks to xxl. I have...

    I will change the front shocks to xxl. I have some around I can rebuild and put on there. I don't do any serious jumping right now. I have a small hill I jump periodically in my backyard and get...
  3. Replies
    15
    Views
    801

    Haha good point clearly I didn't look at you...

    Haha good point clearly I didn't look at you location!
  4. Replies
    15
    Views
    801

    I agree, I highly doubt it is the new vxl. I am...

    I agree, I highly doubt it is the new vxl. I am certainly now opposed to going higher than 3s if it will get the truck where it has some top end and I do not have to constantly worry about the motor...
  5. Replies
    15
    Views
    801

    Are you bashing in grass lespaul02 and what kind...

    Are you bashing in grass lespaul02 and what kind of top end are you seeing?
  6. Replies
    15
    Views
    801

    The hottest I have seen it since I bought a temp...

    The hottest I have seen it since I bought a temp gauge was 182 with 11/54 that was before I replace the bad motor bearing. I know the motor has been hotter because right after I bought it it was...
  7. Replies
    15
    Views
    801

    Slash 4x4 MT Conversion Feedback

    Hello all,

    Looking for thoughts on my slash 4x4 MT. I just bought this truck used early this year. Came with the Velineon setup, aluminum arms and shock towers, MIP X-Duty shafts and some other...
  8. Replies
    15
    Views
    1,129

    Thanks for the feedback madkawi650. Based on...

    Thanks for the feedback madkawi650. Based on your experience with these tires it sounds like my expectations are too high of these tires. I think these tires are going to end up on the wife's pede...
  9. Replies
    15
    Views
    1,129

    Update - I pulled the front and rears off, washed...

    Update - I pulled the front and rears off, washed them really good with soapy water and a brush, rinsed, dried and put them back on. Unfortunately, no noticeable difference with the Slash in grass...
  10. Replies
    15
    Views
    1,129

    Thanks skmfkr, these tires are brand new with 5...

    Thanks skmfkr, these tires are brand new with 5 or 6 runs on them so far. I will wash them and give that a shot tomorrow.

    I am going to put them on my Jato tomorrow if washing them doesn't help...
  11. Replies
    15
    Views
    1,129

    2.8 Trencher wheel spin

    Hello,

    Has any one experienced excessive wheel spin with the VXL system, 3s, 11/54 or 12/54 gearing, Revo slipper with taped and glued 2.8 Trenchers? When I say excessive I can't even get the...
  12. Replies
    2
    Views
    420

    Everything was fine, well driveline related. I...

    Everything was fine, well driveline related. I took it out to the largest parking lot I could find with no activity so I could watch and listen. The throttle linkage was off by about 1/2". ...
  13. Replies
    2
    Views
    420

    Jato Tranny Issues

    Hello,

    I have had my 3.3 Jato for somewhere between 6-8 years and still have not put a full gallon throughout it yet. Never had any major issues besides burning up the rear tires and broke a...
Results 1 to 13 of 13