Type: Posts; User: Braedonsz
if you have spacers on your shocks, pull them out to ease off the springs.
man, sounds like i need a new set of friends, friends with 'spare' 3.3's on hand :D
And just to clarify :p
Lower tooth count on spur = high top end, low end (no wheelies)
Higher tooth count on spur = low top end, better low end (slightly better wheelies)
Lower tooth count on...
i think the 2.5 tranny will take a spur as low as 68, could be wrong, i think thats the lowest traxxas offers...
Try losening the nut on the engine case that holds the carb in place. you might...
looks good, are they custom ramp plans?
the silver really sets the purple off, looks nice
I'll second that request :p
I havn't been able to find top guel anywhere in the Greater toronto area, so i'm wondering if hobby shops here in ontario don't carry it. I use morgan sidwinder. i think it's great.
Plastic, as mentioned, much easier and cheaper to replace a spur then tranny parts. I have only stripped one in the last 4 gallons of fuel, and broke and engine mount at the same time. Plastic are...
george16, what tires to you have on there?
right now i only have three in, as i broke one of the feet on my engine mount:wacko: for the second time :wacko:
but, it's has been running fine. if you have thread locker on the two that are...
wheels wont spin untill the spur flies. However if you use your fingers to spin the small Small black rod sticking out of the tranny case (right next to the trottle/break servo) then the spur should...
so, sounds like i'll be well off with the Mugen buggy filter
(That the one?)
My stock air filter is looking rather sad, and i'm looking to get a new one. Any suggestions for one i can just pop on there?
your going to get many different company names here :p One thing i do recomend is staying with stock bumber mounts. The flex in them is good for saving bulkheads in minor head on's.
One thought i had was the glow plug, but right after that thought, i was able to get it running for a get 9-10 WOT runs, but then it went buggy again... and after it goes buggy, I can't pinch test...
I have a t-maxx with the 2.5, and this is what it does :p
I start it up, get's up to operating temp, runs great for a while, then cuts out (I thought, over heating) so i make it a...
You can find white parts that are meant to be dyed, they would probably work for you..
I know what your saying bud, We have a good 2 feet of snow out there right now, and i had the truck all ready to go months ago :p .
Yeah, that perticular one looks better on the Savage. I believe there is one VERY similar made fot the T, I'll take a look and see if i can find a link... it fits much better...
Top dead center? Does it turn at all? Or is it locked up completely? If it is, see if you can turn the flywheel manually.
I do somthing similar, I hate the paper methood, I think it allowes to big of a gap. imo.
But if you think about it, How much damage would a couple seconds of running lean cause? Like, just 3-4 seconds, enough to cut your lap time down by a few 1/4 of a second?
spur and motor mount, landed upside-down aff a fair size ramp...
House- that was my case, I was four turns out, trying to retune, getting very angry, and then decided to start at 3 turns. I needed to lean it maybe three 1/16 turns before if was perfect. So i'm...