Search:

Type: Posts; User: new2revo06

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. I just ride around in my backyard and do small...

    I just ride around in my backyard and do small jumps, I have stock springs, but 45wt in front and back. However, I have some rear sag so I'm looking at stiffer springs and maybe some thicker oil.
  2. Replies
    12
    Views
    688

    The main reason for them breaking, besides that...

    The main reason for them breaking, besides that they are pretty weak material, is that usually the exhaust pipe and the header are too close together, leaving no room for them to move even a bit but...
  3. Thread: spur gear

    by new2revo06
    Replies
    5
    Views
    343

    Basically, the farther away the numbers are, such...

    Basically, the farther away the numbers are, such as 15-40 you will get better acceleration and low end. The closer the numbers, such as 15-36 the more high end power you get but you lose low end.
  4. Replies
    23
    Views
    399

    I have non-recharable Venom batteries for only...

    I have non-recharable Venom batteries for only about $2 for a pack of 4 and they always last.
    I have never tried these, but since I personally think Venom is a great brand for batteries you could...
  5. What happened to me- I am not sure, but it seemed...

    What happened to me- I am not sure, but it seemed that it had to do something with either the EZ Start motor or the OWB. The same problem happened to me and all I did was take apart the gears in the...
  6. Replies
    10
    Views
    449

    I definitely agree with that, they break so...

    I definitely agree with that, they break so easily when landing upside down, which is why I got a wing to protect then engine while I jump.

    Installation is not that hard it just takes a bit of...
  7. Replies
    5
    Views
    319

    It may not just be the needles but humidity. When...

    It may not just be the needles but humidity. When its humid out i can barely get my 3.3 to idle for a few seconds.
  8. Replies
    9
    Views
    484

    Yup, I don't have the anodized GTR shocks but...

    Yup, I don't have the anodized GTR shocks but what I heard as that since they are anodized, the material does not come off. However with stock pistons the black material rubs up and down and causes...
  9. Replies
    24
    Views
    538

    Actually the aluminums will not bend, but just...

    Actually the aluminums will not bend, but just snap. The RPM ones are the ones that might flex instead of breaking right away, and the warranty. I also heard they were very strong.
  10. Replies
    5
    Views
    240

    Thanks for the quick reply, but since it is late...

    Thanks for the quick reply, but since it is late I will have to check tomorrow.

    Any other thoughts?
  11. Replies
    9
    Views
    618

    Yes, it does make a bad smell, but baking them...

    Yes, it does make a bad smell, but baking them works and is safer for the tire. Just start off for about 10 minutes at about 250. Try to pull them off (not with your bare hands :)) and if they are...
  12. Replies
    11
    Views
    334

    The only thing I can think of, besides the clutch...

    The only thing I can think of, besides the clutch bell which is not in the back of the truck, would be a loose screw- just check all screws and anything that usually spins.
  13. Replies
    6
    Views
    319

    This may not be too helpful but weather can be a...

    This may not be too helpful but weather can be a problem, and for your number 2 about it cutting out with low throttle happens to me a lot when its humid outside.
    Good Luck.
  14. Replies
    10
    Views
    391

    Yes and if you don't prime its going to waste...

    Yes and if you don't prime its going to waste your battery for no reason.
  15. Replies
    5
    Views
    240

    No Power to Rear Wheels

    Hey guys, I kinda have a problem here. My Revo seems to be getting no power or very little power to the rear wheels. With the truck in the air it seems that both wheels spin at the same rate, but on...
  16. Replies
    20
    Views
    665

    I say definetly get one, for protecting the...

    I say definetly get one, for protecting the engine, and also to what ajb1205 said that it protects your body, mine is already beat up.
  17. Replies
    6
    Views
    318

    First of all its always better to do after run,...

    First of all its always better to do after run, whether its just WD-40 or some After Run Oil. From what I know if you are going to use it within a few days its ok because its not enough time for the...
  18. Replies
    1
    Views
    151

    quick moab tire question

    I just have a quick question, I am about to glue my Moabs, but can someone tell me which way they go, thanks. A pic would be good but i just need anything fast please.
  19. Replies
    6
    Views
    307

    Yup, I usually ride my truck at least one every...

    Yup, I usually ride my truck at least one every few days so WD-40 is what I use.
  20. Yup, just bake them- and don't be afraid the...

    Yup, just bake them- and don't be afraid the rubber won't melt. If the glue is still strong you don't have to raise the heat, just keep them in for longer. Mine took about 25 minutes but they didn't...
  21. Replies
    3
    Views
    307

    Oh, Thanks. So now that its probably going to be...

    Oh, Thanks. So now that its probably going to be 17mm, what tires do you think i should get- wheels aren't that important because I'll probably just get something like dish rims.
    Also, 17mm can hold...
  22. Replies
    10
    Views
    384

    Almost the exact same thing happened to me, and I...

    Almost the exact same thing happened to me, and I thought the servos were dead. Luckily it was a minor problem- the pivot balls and pivot ball caps were too tight and wouldn't allow the wheels to...
  23. Replies
    3
    Views
    307

    Wheel and Tire Opinions

    Ok guys, here's where I am right now- 4 stock talon tires with foams, 3 stock wheels. I want to get new wheels and use them with the stock tires but theres not that much choice for me. First question...
  24. Replies
    13
    Views
    477

    Ok, I have stock talons so I'll keep it at 300....

    Ok, I have stock talons so I'll keep it at 300. Thanks
  25. Replies
    13
    Views
    477

    Thank you so much guys. I think I'll try it at...

    Thank you so much guys. I think I'll try it at about 300 and leave them in there till they come off. If thats not hot enough I'll raise it up to 350. Thanks again :).
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4