Type: Posts; User: RC_Basher
can i use a hot glue gun to mount my tire on my wheel. or will super glue work better. local hobby shop to far away and want to be able to run my car tomorrow.
FlySky FS-GT3B Digital 3ch 2.4ghz TX & RX LCD Transmitter & Receiver is a good TX but eats the AA up fast to. for 35 dollars
it might be some that painted there own.
you need a bigger battery for sure and i would stay with the 19. IMO get a temp gun then keep uping the gear to your liking but keep it under 170 degrees
i have the ezrun 35 amp and the tecon 3200kv motor and i run 23/83 and barley hot after to 7 cell 5000 mah onyx batteries
i am wanting to the RPM wide mod on my rustler for oval racing. can anyone help me with the parts i need to get i know the other ways but dont want to do them just the RPM rear A arms. any help Thanks
Sweet Thanks Moto wonder why it didnt do that the first time i set it.
i am wondering on my brushless system when i am running it why i do not have a middle speed its either full blast or nothing at all is there some thing i need to fix on it or do all brushless do this?
ok i have RPM rear A arms and RPM barring carriers do i need to change them to something diffrent? FLM Tranny will put that on my next to buy list. new tires have been looking at Bowtie Tires is...
I am racing Oval with my Rustler i just put a Ezrun 35 Amp Esc and a tacon 3200 KV motor on it. i am now having trouble not spinning out can anyone help with this. any advice is a plus. stock shocks...
can some one help me program my ESC with my TX i wasnt thinking and didnt get a program card with it so if some one could help me that would be great
any special tires i need? i am using my slash tires now.
were can i Buy a late model body for my rustler and what all do i need to do to make it a late model
Pavmentsurfer sent you a PM
35a 9T ezrun is this a good brushless system was thinking about getting it but was not sure if it was a good deal as it was cheap glad i seen this post. how fast will it make my rustler? i have the...
I bought the Electrifly S_600 motor last week the only problem i have there is the shaft is small have to put the pinion on backwards to tighten the pinion down.
no cant get it to pup a wheelie for anything lol
dont think i will put a brushless on this i am getting one for my slash some time but this one is just for bashing. I love to Jump with it last jump i hit broke rear Arm and snapped the 2 screws...
oh and i have RPM rear Arms as well
you turn on your controller First?
Ok i bought a XL-5 about 2 months ago.
RPM front Bumper
RPM Rear caster blocks and ball bearings
Now what should i get next.
I have had to open my case and move the gears around a little bit in there and then put it back to gather and it went back to being fine. but i have a XL5 so not sure if the transmission is the same...
mine has the LVC on it but my Brothers does not.
ya the Throttle trim if its not in the center when i turn on my car i cant go forward or backwards tell i put it in the center then it goes.
would the stock 12t handle a lipo if so what size i might just go lipo?