Type: Posts; User: slashbash4x4
The battery needs a female tamiya style connector. Most hobby shops will have them. They might be called something different for example i thibk traxxas calls them molex connectors. Usually pretty...
Awesome thanks guys!
Soft tires make a big difference! I think some trucks like the ultimate and platinums come with soft compound factory tires versus the hard ones on the regular edition.
My setup that pulls...
Yeah that happened to me also, try prying it off with screwdrivers. You will likely need a new bearing afterwards no matter what you use to get it off.
You can try heat but you will melt the seals...
Yes i would run a voltage alarm/buzzer
I, already run lipos in my electric so i have the whole charging setup. And I have those two batteries that are too small for my slash and I, dont have a use for them.
A 6 cell is more than that fully charged though... Just like a 7.4 lipo is actually 8.4 fully charged..
I have a couple 1800 MAH 30C 2S lipos that i dont have a use for. I was wondering if the EZ Start could handle a 2S?? A full charged 2S is approx 8.4V.. Not sure what a fully charged 6 Cell Nimh...
Holy next task try and find a 1mm hex
Isnt it a hex though?
Hi. I posted this in another section but no answers yet so i was wondering if any of you could help me out..
I went to rebuild the VXL 380 in my mini but i could not find a way to remove those tiny...
Went to go rebuild the,motor but how do you get those tiny little screws out of the endbell? I can find any hex small ..
I think i am just going to find a used can. Thanks guys
Still looking for one
Hi. I am looking to buy a wrecked rotor out of a VXL 3500. Hoping someone out there has one where the magnets come off or something
Kruse, do you mean a can or rotor?
Hi. I am looking for a new or used motor housing with the windings in good shape.
Hoping someone out there has one from a motor that has blown a rotor..
Also looking for a garbage or wrecked...
Hi. So today my VXL 3500 disinegrated a bearing and the can is no good. The rotor is fine. Talked to Traxxas, can do the warranty thing for new 3500 for $35+ 15 shipping.
So I am Open to...
Lots of threads out there just take a quick search.
I strip my truck down. Usually take tires, electronics, tranny, engine, exhaust off maybe more components depending on how dirty it is or how...
1) center diff is sending too much power to front wheels. Open up tranny and put a thicker oil in the center diff. You may have to research what weight to put in. I think most run a 500,000K in it???...
Will the 2s Sky lipo 1800 40C fit?
also make sure the pin in the primary gears in the trans is in place and the clip holding it in place
the shift servo only works the forward/reverse gears.
1st and 2nd gears are all controlled inside the transmission.
Play with your shift set screw through the access hole in the top of the...