Type: Posts; User: wrnchbndr
you can do away with the servo saver for a much tighter front end.
Now go back out there and hit the pace car!
novak is comin with these 550 motors. should be very good in slashes.
I have to disagree with you on that point. I have the protac setup on mine and the thing feels like it has sway bars on it.I also have the outlaw chassis and imo it is the BEST setup for the slash ...
the outlaw chassis and pro-trac suspension is a very good setup imohttp://i687.photobucket.com/albums/vv233/wrnchbndr/P1010076.jpg
The slash will fit fine inside fhat bag. I have a similar one that I found a cardboard box that fit inside. Nice and sturdy.
you have the wrong servo horn on there. the other one lifts up away from the servo. I dont think I have anymore steering than i did before, but i;ve always had plenty of steering
it has a built in servo saver and does away with the sloppy one on the servo. KIDD3, I am running an outlaw chassis so my servo mounts in a different place than yours the only adjustment you should...
very well said. great explination.
i put the 4x4 parts on mine and it was a drop in. super smooth and free.
yeah the stock wheels stick out 10mm on each side
the arms are 10mm on each side=20mm
you can use the traxxas fiber washers to shim out the slop. carefull not to over shim and make the steering tight.
sounds like a bent hinge pin
rear toe is 3 degrees
i am running the integy trans and front bulkhead. i have used integy parts for a long time and have always been pleased with everything i have gotten from them. 98% of people bash integy based on...
prolines protrac suspension
+1 on the velcro also helps hold the body on.
you want to water dip at low voltage. what you are trying to accomplish is seat the brushes with minimal arcing. low voltage helps keep it to a minimum. I have had great sucess adding a couple of...
If you race the boca's are very nice.( the ceramics) Just bashing, overkill IMO
I just put the Evolution HD integy trans on mine and it bolted up perfectly. Is that the one you have? I dont see the v2 on their sight.
you have to have 'em on photobucket or some site like that and link to 'em
thats the two wheel drive set-up
stock spec set-up
Heres is an update on my truck. I got my trans and bulkhead installed with no problems,simple parts swap. Also installed 4x4 steering.