Search:

Type: Posts; User: xargon321

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    18
    Views
    1,879

    if your a racer or want speed get the 40c 5000 if...

    if your a racer or want speed get the 40c 5000 if you want to bash around for a hour or more get the 8000
  2. dont look like it, looks like it just for 5-6...

    dont look like it, looks like it just for 5-6 cell packs
  3. Replies
    14
    Views
    935

    also check the temp at the same place every time...

    also check the temp at the same place every time because the top of the motor will be cooler then then bottom. the shroud is made so it forces air around the fins and out the bottom of the motor it...
  4. Replies
    11
    Views
    750

    that's just too cumbersome and to easy to break...

    that's just too cumbersome and to easy to break stuff and/or lose stuff not to mention too much $$$$ 40 dollars a cell? it might be good to look at if it was 15 per cell
  5. Replies
    13
    Views
    368

    that means don't pull more then what the...

    that means don't pull more then what the batteries c rating. is if its 20c dont pull more then 20c or you could dmg the battery. its a general warning label that gets put on a lot of batteries so it...
  6. Replies
    17
    Views
    1,051

    if you store them fully charged they will lose...

    if you store them fully charged they will lose capacity quickly and as they lose capacity they lose the ability to deliver the amps. if you using the stock system the motor can draw 100 amps max. if...
  7. dont bother stocking up on the bearings get some...

    dont bother stocking up on the bearings get some boca set and replace them as they wear out.
  8. Replies
    11
    Views
    460

    if thats right out of the truck i dont think the...

    if thats right out of the truck i dont think the slipper was tight enough and let it slip to much that would heat up the spur gear and let the pinion chew it up easy
  9. Replies
    11
    Views
    460

    slipper not tight enough? or was your motor to...

    slipper not tight enough? or was your motor to tight on the spur? i burned my orig clutch and it was piping hot. might have softened you spur enough to let the pinon chew it up like that
  10. Thread: 2650 Pinion?

    by xargon321
    Replies
    7
    Views
    672

    the main cause of pinion failure that i have seen...

    the main cause of pinion failure that i have seen is because they over tighten the set screw and it cracks the pinion and makes it fail under load. i run the stock one and have not broken it yet just...
  11. Replies
    6
    Views
    557

    you CAN over draw a battery it will cause it to...

    you CAN over draw a battery it will cause it to heat up and fail fast if you do.
    the stock motor can take 65-100amps depending on what your doing so make sure your discharge (C rating x capacity) is...
  12. i just got the hardened steel shock shafts and...

    i just got the hardened steel shock shafts and aluminum caps and some springs and thicker oil for my shocks. then when i bent a shaft i just rebuilt them all. its kind of funny but the "big bores"...
  13. Replies
    22
    Views
    819

    Spc racing has a 8000mah for like 72 for the 2s...

    Spc racing has a 8000mah for like 72 for the 2s and 100 for the 3s. i would go to hobby king and look at some of those you can get a 2s 5000mah 30c hardcase lipo for $23 it might not have the run...
  14. Replies
    6
    Views
    443

    ya make sure you joined the super saver club so...

    ya make sure you joined the super saver club so you can use the 50 off 250 coupon and get free shipping
  15. Replies
    22
    Views
    819

    Calibers should be run on dirt only other wise...

    Calibers should be run on dirt only other wise you wear them down to fast. for the price of 1 max amps battery that runs 80 mins you can get like 8 5000mah 40c Hobby king lipos shipped to your door...
  16. Replies
    18
    Views
    1,144

    i would say the 2650 unless you going to run...

    i would say the 2650 unless you going to run lipos over 4s. thats the motor castle recommends for the 4x4
  17. Replies
    18
    Views
    1,144

    it does fit in the stock location thats where...

    it does fit in the stock location thats where mine is
  18. Replies
    18
    Views
    1,144

    2650 only takes up to 4s and is faster then 2200....

    2650 only takes up to 4s and is faster then 2200. 2200 can take up to a 6s and is a torque monster. i just got the 2650 because Castle recommended it for the 4x4.

    i think both motors would run...
  19. Replies
    18
    Views
    1,144

    they will work fine. they might get a little...

    they will work fine. they might get a little warmer then the stock system but nothing to worry about. part 5626 is not necessary to mount the esc but it make it easy. you might get the revo slipper...
  20. Replies
    8
    Views
    594

    rjames whats you battery? size and c?

    rjames whats you battery? size and c?
  21. Replies
    12
    Views
    1,387

    as long as its has not gone below 3v you can...

    as long as its has not gone below 3v you can charge it back up. charge it to full and see what your multimeter says again, then run it for a few min and check the battery if that cell is dropping...
  22. Replies
    7
    Views
    336

    i think max constant current is like 120 amps for...

    i think max constant current is like 120 amps for the motor. and chances are you'll never pull that long enough to do anything to most batteries i have 2 2s 20c 5000mah lips and they barely get warm...
  23. Replies
    8
    Views
    594

    is it shuting down as in stopping or going into...

    is it shuting down as in stopping or going into 50% mode? the red light blinking fast is a thermal shutdown blinking slow is lvc
  24. Replies
    12
    Views
    480

    can you post a picture of them? that should not...

    can you post a picture of them? that should not be happening at all i would go back to the place you got them and talk to them
  25. Replies
    12
    Views
    1,387

    no that's total voltage from the pack when you...

    no that's total voltage from the pack when you measure you voltage with a multimeter you have to move your ground to the one you just tested to get the next cells voltage
Results 1 to 25 of 84
Page 1 of 4 1 2 3 4